Aygrochy Inline duct Fan 150mm/6 inch, Extractor Fan with Variable Speed Controller, using for Bathroom, Office, Grow Tents, EC motor 2800 rpm, UK Plug

The fan comes with a controller and a plug in temp sensor. Power goes to the fan via the 3 pin plug then the controller can be placed approx 2 mtrs away and the temp sensor another 1.5 mtrs if needed.The fan has 10 speeds and the controller ramps up the speed in steps so keeps the current draw low. The ‘auto’ setting wasn’t quite as automatic as I’d hoped as in it won’t vary the fan speed to suit the temperature set point. Instead you pre-select the desired speed setting and the controller turns the fan on/off according to the temp or humidity set points. You can give it maximum and minimum set points to run the fan within so it’s quite flexible, will take a bit of trial and error playing with the settings but it will make sense (note you have to put a value against each one of the high/low temp and high/low humidity before the controller is ready to take over (those parameters flash at you indicating they need attention) I am not tech savvy but managed it fine.The fan itself is well put together and can be easily split away from the casing and withdrawn without disturbing the ducting either side. Fan is quiet and doesn’t vibrate at all, on speed 10 the air noise is more pronounced.

I use it for a laser cutter as an extractor fan, and so far it works pretty well.Easy to access for the impellers to clean off the dust, very quiet, yet strong enough to eliminate all of the smoke.I can recommend this product if the extractor have to remain in the same room as the working area.The adjustable switch is a real plus.

This fan is great used as a bathroom extractor. I mounted it using some anti vibration pads in the loft and yes it makes a bit of noise when going full speed but it’s purely the movement of air, not the motor. Overall great product.The only thing I would say which I thought would improve the product is to have automatic fan speed increase with humidity increase.At the moment the controller operates on trigger points that you can adjust (e.g. fan turns on at xx percent when it reaches say 70 percent humidity).But it’s either on or off, yes the speed can be adjusted but only for all programs. It would have been good for it to work incrementally, e.g. 60 percent humidity brings the fan on at 30 percent say, and if the humidity of the room should further increase 70 percent then the fan speed increases to 50 percent speed and so on.If that was possible I would say this extractor was perfect. Still a fantastic product though.

Good quality and quiet keeping me cool will be back

We tried this with no other noise in a cellar at night in the countryside which is as close to silent as you get. It sounds like a jet engine. You can hear it two floors up. You can see that on the photos. Both watches measure the same. It is a fan and seems to work as a fan. But it is absolutely not quiet in any way! Returning as NOT as advertised. Well over 100db not 32db as advertised. Waste of my time.

The fan and controller are good quality and the fan is well balanced. The only problem I have (which is a fairly big problem) is that at slower speeds (below half) it emits a very loud hight pitched whistle that makes it unusable to have on at night.Edit* The high pitched whistle was the alarm letting me know the temp probe wasn't connected! Once connected it was completely silent and worked brilliantly. Uprated to 5*

Bought the 6" model and generally pleased. It is noisier than hoped buti have mine suspended from the bracket rather than mounted to something solid which mitigates noise a bit.Even at low speeds it is moving plenty of air.Speed control is a little slow to respond but works well. Would be nicer if it gave rough rpm levels. Lead to the speed control is a stingy 1.5m.Power lead also stingy at 1m.

Very good value, simple to set up and easy to use