MirthobbyRC 30A Brushed ESC Motor Electric Speed Controller 4~8v with Brake for 1/16 1/18 1/24 RC Car Boat Tank

After installing this brushed ESC on my Wltoys k989 RC vehicle,And testing it out I noticed a reduction in power and speed in my Wltoys k989 RC vehicle buy small amount, but it was still fast enough and controllable as a result and the motor runs much cooler as a result. As far as I'm concerned it was a decent trade-off to be able to have more control over the RC vehicle and made it much smoother running its on the streets as a micro RC vehicle. this brush ESC is a very decent ESC for the money. But I would recommend that you keep an eye on the LiPo battery, I am aware that these micro brush ESC's may not have a lipo cut off so be aware that. Otherwise. The ESC that I got works perfectly well.

I installed this ESC in a wltoys k989, which uses a 2s battery and a 130 motor -- 30A is WAY overkill for this load, and it should have been fine. Everything was wired up properly because it ran for a full 20 minutes before I had to recharge, but once I recharged the battery and fired it up again it just sat and ticked until it released the magic smoke. Would not buy this again.

Well it only had to lower some legs on a model truck but it just ran and would not stop. After getting it hooked up right and having to adjust the trim all the way to the right I stopped but it only would work one direction. Then after hooking up again it popped and smoke and stop working save your money and get something better .

Works great for 1/24 scale wltoys a202 buggy, i was looking for something small and affordable to replace the stock 2n1 receiver esc unit, using a flysky transmitter along with a mini savox servo. Stock motor and stock 2s lipo, zero problems.

Funny as it may seem been into the Rc thing for awhile now and knew nothing about these brushed esc that you can install in basically any old school Rc car and bring it bk to life.