CB Radio Antenna Mount Bracket Holder for Jeep JL Wrangler 2018 2019 2020 2021

First, the hole in the bracket was too small for my antenna. I drilled it out. Then when I went to mount it, the spare tire and rim hit, so had to cut a big portion of the bracket off and drill a new hole. This was for it to fit a stock 18" rim. Probably is fine if you have an aftermarket rim with less backspacing than stock.

I like the fact that it was easy to install just pulled two bolts out put it in front of those holes involved it back down that was it and you can't even tell there was any work done other than the fact that there's an antenna right where you need it and no drilling holes good job Amazon!!

It isn't worth the money as it's a lot lighter than I thought it would be. I'm not sure if I'll be keeping it or sending it back.

Simple installation and it works. Sanded down the bolt holes to get a decent ground SWR was 1.4 - 1.9 after tuning, so ground is decent.But it digs into the spare tire. I put a 1/2” wheel spacer on the spare tire mount and there’s no rubbing now, but the chintzy black plastic reverse camera shroud doesn’t fit now. No big loss.For 20 minutes of work I’m pretty happy. This is the wheel spacer I used to make it fit: VLAOSCHI Black 5x5 5x120 5x127... https://www.amazon.com/dp/B08XBL6QM1?ref=ppx_pop_mob_ap_share

Doesn’t fit with stock whee