Yosoo M16 16mm 2 Pin Screw Type Electrical Aviation Plug Socket Connector Used in Data Acquisition Systems and Electronic Connector of Aviation (2 Pin)

Received quite fast, installed them and ready to go. Thank you.

Exactly what I was looking for to make my own plug. Great price too!

Nice tubes to slip wire in and solder too acted as a 3rd hand. Used this to replace a broken one on an electric scooter and battery chargers end fit right in and works perfectly.

Perfect match for the NanRobot charger. My son ripped the cord off the scooter. This was a quick fix. Easy to replace the old tip with simply removing the screws and replacing. Not much work at all. Now I have two chargers which charges the scooter faster because it has two ports for charging. I bought another charger and ordered this replacement tip.

Used part for Burromax 350 charger. Replaced cable and connecter. This part was a upgrade, from factory. It screws on the bike. Perfect fit.

Soldered to 16 AWG Wire from Charger. Used to charge Lithium 12v Battery that has a male charging port of the same configuration. After 3 cycles it worked flawlessly.

I have an Evercross H5 (a.k.a. H24). The "female" of this pair is just dandy to replace the very breakage-prone end of the chargers for this e-scooter, and reportedly there are quite a few which use this form factor. The original charger ends are all fragile plastic from stem to stern, these things are much stronger plastic for the insulator with metal in various nice places. It also includes a great strain relief, I added a few layers of electrical tape to engage it. Does need careful soldering to make it happen.

I bought the 3-pin version with the male pins in a chassis mount and the female pins in a cord mount.I removed the tiny screw on the female (cord) connector but could not remove the hard plastic part from the metal shell.I THINK you need to twist the plastic part after removing the screw but I'm not sure as prying the two pieces apart caused the plastic to break and the #2 female pin connector to fall out. I had to epoxy it in place after soldering.Then I dropped the tiny mounting screw and after looking for it for 30 minutes gave up and epoxied the shell onto the plastic part.The plug works fine now. I'll never get it apart again, but that's okay.Don't force the plastic parts. They break. There are multiple videos on the site, but none show how to disassemble the shell from the pin holder.

Die Steck-Anschlüsse wurden für die Spannungs-Versorgung von 100W UV-LEDs verwendet siehe Bild, wobei die Stromversorgung der LED und des Ventilators darüber lief.

Prix trop élevé

Ottimo connettore per mantenere la polarità.

Perfetto!