SEAFLO 14A Series Narrow Low Profile Water Level Sensing Automatic Bilge Pump (1100 GPH, 12V)

Works well & keeps water level in bilge a lot lower

using for shower sump in a boat. wire it up for automatic and switched, or just switched. If only on automatic it may not empty the sump because it's float activated. not like those Rule pumps that check for water every 3 minutes.

setup as instructed using the Brown white cable fused but when set in water the pump doesn't work. Manual Brown wire works fine. disappointed....

Pump is what I expected but I had to search the web for all dimensions and details. Otherwise the price is attractive and shipping affordable wit a fast delivery. No hidden tax for Europe. Smooth transaction, Thanks !

After many years of service, my old Jabsco remotely mounted reciprocating pump failed. A like replacement pump was either not available and/or cost prohibitive.This little pump fits nicely down in the bottom of my bilge and has a huge pumping capacity.It has now been in place for 3 months and has kept my bilges dry so far without any faults. We shall see how it holds up for the long haul, but for the purchase price I can keep 3 or 4 spares onboard for half the cost of a replacement Jabsco pump.

This is a repurposed pump. It is new though. Did not come in any box, just a plastic bag, taped. All parts were here, but here’s the catch. There is a connector on the power wires but no mating connector to use to hook up. Usually the pumps come with wires with no connector. This was meant to be sold in bulk is my guess.The connector clip was cracked in half because it was delivered in a plastic pouch. I’m cutting it off because there’s no mating connector included.

The pump that came was not the automatic sensing pump advertised. I needed to install the low profile pump ASAP and the pump fit the profile and when attached to a float switch performed well. Because of its small motor size I was worried it might not be able to pump up the approximate three feet elevation from bilge floor to seacock but it did ok. There were no written instructions but some wording taped on the actual wires gave the basics. Would I get this one again? YesDon Hester

I needed a thinner bulge pump than the standard size to fit in the middle of my boat. With this mode, I was able to get both a pump and the float switch.