20 Sets Mini Micro Sh 1.0mm Jst 3-Pin Connector Plug Male with 150mm Cable & Female

I Connected it to the debug header on the RPI 5. TTL (red=TX) (black-GND)(Yellow=RX)The wire was good quality. Stripped easily and was easy to solder.

Item as described and the quality of the wires is actually quite nice. Solders well and tensile strength is more than adequate for the applications. The issue that I ran into is already well documented here: the center and side pin colors are swapped. It's an easy fix as long as you have an Xacto knife, safety glasses (always wear those!), and dexterity. So far zero pins broken switching around the wires.

Was able to replace my cpu fan on my ACEPC with this kit.

Caution - These are nice quality wires / connectors, EXCEPT the ones I received were 1.25mm and not 1.0mm so I had to return them. Not sure if it was a mistake or if the description is wrong.

This is the right connector for the SWD debug connector on a Raspberry Pi Pico H. A tiny bit of insulation is removed from the bare wire ends. I couldn't strip any more off with my simple tools (they cut through the wire) but managed to solder them to wires whose other ends have breadboard connectors. I needed only one but mangled two while doing this so it's good that you get many in a pack.

These are wired wrong as most servos and receivers have the black ground wire to the outside and not in the middle like these. After I pulled and swapped the red and black wires they worked fine.

The package I received was labeled as SH connectors, but the contents are smaller than JST-SH. The pitch between pins are only .8mm which will not fit the SH 1mm spacing on the circuit board I bought these for. Returning.