Cameron Sino Battery Replacement for JBL Flip 3 Battery, JBL Flip 3 Splashproof Portable Bluetooth Speaker

Compré esta batería para cambiarla a mi JBL Flip 4 que, según he visto, ha presentado problemas de duración de la batería de forma recurrente a muchos usuarios. La batería llegó bien, en el tiempo esperado y bien empacada.Sacar la batería anterior del parlante fue terriblemente complicado. Por el diseño del parlante, hay un cable ribbon que debe moverse para poder sacar la batería, lo que fue bastante difícil. Luego, la batería está tan apretada en el compartimiento donde se aloja que, para sacarla, hay que dañarla. Leí de personas que usaron un sacacorchos, perforaron y halaron la batería. Mi sentido de preservación no me permitó hacer eso, así que usé unas pinzas de punta delgada para agarrar y halar la batería hasta que pude sacarla, en todo caso, sufrió daños evidentes, aunque no explotó...Armé todo de nuevo con la batería nueva, pero el parlante quedó funcionando aún peor... por algún motivo, el parlante no carga la batería, pareciera detectar que está llena, y deja de suministrarle corriente, así que sólo funciona unos minutos...En fin, no invertiré más dinero en esta reparación, así que optaré por otro parlante bluetooth... en todo caso, estoy seguro que la batería está bien, el problema en mi caso está en el circuito que debe cargarla dentro del parlante

Replaced my jbl flip3 battery with this. This was a bit slimmer than the one removed. But fit fine in the speaker and all has been great after the swap. Changing the battery was way too difficult only because of jbl’s fault not this battery. I used it over two hours twice and have yet to run down the batteryUpdate 11/25/2023 - continue to use my jag speaker with this battery and have had no problems with charging or battery life

This adds value by reducing electronic waste. It was easier to install than I anticipated though go I had to search for how-to videos online.

No issues so far.I have the JBL3 variant where the battery compartment is not easy to access. If anyone who reads this has the same version, first drain the battery as much as possible to reduce risk, then tackle it with patience. It is doable but it will be annoying. There's a lot of glue and silicon. I found that the cable blocking the battery was easier to remove by wiggling it from the control board side. The old battery had swelled so this wasn't a simple task.

I replaced the old battery which was dying in about 20 minutes after a full charge. Whole process took about 15-20 minutes. This new battery has been working great. I have got probably 6 hours so far on a single charge and it is still going. I have only had it installed for about a week so far so we will see how it holds up over time.

Before you buy a replacement battery, see if you are able to access and remove the existing one... It took me at least 90 minutes to replace the battery, and I am experienced with and enjoy repairing similar small electronics (e.g. laptops, iphones, etc.). I started by looking for instructions on youtube and ifixit, and discovered that no two were alike--and that none of them showed a device precisely like my JBL Flip 3. It seems that JBL went through many different iterations of this product. Some versions allowed access to the battery from the side, but in my case it could only be reached from the end. I did finally get it all put back together and it is working fine with the new battery (I can't comment yet on the battery life...). But I would recommend that only people who really enjoy this kind of work and are comfortable improvising (because you may very well not find instructions that match your device precisely) try this. (Good fine motor skills and good near-vision or loupes also help).

My JBL Flip 3 Speaker would not hold a charge so I took apart watching a You tube video. I installed my new battery and put my speaker back together. It works great.

This battery is fine for jbl flip. I have an old model and this battery is 5mm more longer. . I have an old flip3 and it can be fit easy with a soddering iron. Your just melt the side of the plastic and the battery will fit easily inside. When you close the jbl nothing is apear. The jbl now can play for the 16 as a new one. I have also a big jbl extreme and i will buy a battery from this supplier if he have this product.àI recommend this supplier.