3 Pack Compatible for Ptouch HSe-221 HSe221 HS-221 HS221 Black on White 8.8mm 0.34'' Heat Shrink Tubing Label Tape for Wire Cable use in PT-P710BT P700 P750W P900 Label Printer

They worked great to print, then shrink rap the label on the wire. No problems yet. I will buy again.

Since my model PT-D210 was not listed it would not work. But after covering the bottom left hole works like a champ. Labels a nice and durable. Do recommend using bold print to make it easier to read.

Get way to label cat5/6, coax, cables, wire in an outdoor, commercial, industrial, dusty, dirty condition. I use for labeling CAT5e, 6, 6a, fiber cables in outdoor, damp and high wear locations.

I am wiring my breaker panel. I wanted to do a clean job labeling wires. I looked at lots of different labeling solutions and came up these Brother compatible heat shrink tube label cartridges.When I first printed one it looked so tiny I did not think it would fit the wires. The photo here shows a 12 gauge romex conductor fits perfectly. Same goes for 14 gauge. A little heat and they will shrink perfectly on the wire.I printed these on my old Brother PT-1750 label printer, so I can confirm it works fine.

The price is great. As good as the more expensive stuff. I used this heat shrink to label wires in a marine (boat) application. I had one small failure to feed problem that wasted about 6" of tube. That appears to have been a fluke. I've since gone through all of the cartridges I purchased without issue. I'm back to buy more. The length in each cartridge is pretty short and the waste on a Brother P-Touch is pretty high so plan on purchasing more than you think you might need.

I can't believe how many years I've gone ignorant of Brother label maker shrink tube. I've been hauling labelers on planes and printing wire labels sideways so i can wrap normal label tape sideways since forever. This stuff is the greatest! Prints beautifully, shrinks beautifully. One precaution is to divide the label 'size' by Pi... (3.14)... to get the tube diameter! Haha, but 5.8mm = 0.70" = no go on 16 gauge MTW, even 18ga MTW is a tight fit. This size is good for signal wiring. Works in all my old timey brother labelers and my PTD400 as well.

Okay, so maybe it's not the greatest heat-shrink (it's thin, no adhesive, and easy to wrinkle), but the fact that I can print inexpensive heat shrink labels with my super inexpensive and old label maker is just too awesome. I was getting ready to spend hundreds on another machine and labels; with these I can use my ancient label maker and it's completely effective and functional! For a hobbyist, these are great!

Used this on a P-Touch XL printer. Printed well on the shrink tubing. Used to label cables. It's not very thick but it works well to label your cables or harness. Make sure to order the size closest to the size of the cable or wire. It shrinks about 2 to 1.