SOCAL-LED LIGHTING 2pcs LED Load Resistors 25W 10 ohm LED Bulbs Turn Signal Error/Blinker/Hyper Flashing

Quedaron funcionando las luces secuenciales de mi Cadillac

Used these on my 2018 Buick Regal Tourx for reverse bulb. Wanted LED lights in there, but installing them caused the reverse light to stay on all the time-- evidently the BCM expects an incandescent-like load on them, so a load resistor seemed like an easy way out.I chose 10 ohm, 25W for two reasons: The stock bulb is a 920 size incandescent which draws about 15 watts. At 14 volts (assuming vehicle is running), the resistor placed in parallel with the LED will draw about 19 watts. So 10 ohms might be a little overkill, but they're readily available, whereas higher resistance load resistors are not. 19 watts is awfully close to the 25W rating of the resistor, which means they will get HOT if used continuously. Not really a concern here, as reverse lights are used for short duration, perhaps a couple minutes max.It worked fine, LED lights work, they come on and off when they're supposed to. Good value, nothing about them made me skeptical of quality. The splice connectors are cheap junk, I chose to solder and use heat shrink wrap at every connection.

I was worried that these wouldn’t solve my LED light problem I had after I bought after market taillights for my 2015 Tacoma.. Well these absolutely solved the Hyper flash problem. They are very easy to install .. took me less than 20mins to install on both sides . They work and that’s all I care about.. now I’m not sure how long they will last .. but so far I’m so relieved and happy.

Installed this on a 2017 Honda Accord I recently upgraded to LED and it started hyper flashing so I found these 25w resistors for the win! It stopped hyper flashing after installing them.

Does the job it does