13mm - 1/2" Self Closed Aluminized Sleeve Heat Shield Protection Side Entry High Temp for Hoses, Wire Harnesses, Cables, Automotive, Exhaust 39" (1 Meter)

Overall summary:- Great adhesive- Easy to install- Good heat protectionI needed to replace the 25 year old OEM wrap an electrical harness near a header. First I tried a product that was a roll of heat wrap, but it quickly pulled apart in places where there were turns. I replaced it with this product and I'm very happy with the result. (see the comparison photo)I saw a 1 star review of this product stating the adhesive wasn't very good. It was plenty strong for me, no issues at all. It was very sticky.More on the tape, its similar to aluminum HVAC tape if you've ever used that. If you've never used it before, imagine aluminum foil from the kitchen but one side is sticky. If you mess up and fold it over, you'll probably not recover. Thats just the nature of aluminum tape, not a flaw in the product.Installation tips:- first, measure the length and cut before peeling the backing off the adhesive- then wrap the line you want to protect- finally, peel back small 2"-4" bits of the adhesive backing at a time and seal that section. Then repeat with the next 2"-4" section

Worked great for job, self sealing makes it almost lock factory installed!

Easy to use and looks good. Adhesive is strong.

Have ordered a few of these. Thermal protection works as advertised.

works well

The adhesive on the one i received is horrible, wouldn't stick to the jacket at all.

I used this heat shield to protect wires on a 2008 Jeep Wrangler. This model Jeep has a problem because the catalytic converters generate a lot of heat and there are several wires and wiring harnesses that get overheated. This heat shield works great because you can wrap it around existing wires. Sleeve type heat shields don't work for this application because the wires are terminated with connectors and a sleeve heat shield won't go over the connectors. This heat shield is easy to use and cuts with a pair of scissors. It makes a very professional looking finished product. All you need to do is cut the length you need, wrap it around the wire/wires, pull the protective tape off the adhesive covered aluminum edge and wrap the edge around heat shield to stick it in place. Easy breezy!