Culligan HSH-C135 Hand-Held Filtered Shower Head with Massage, Chrome Finish

I'm very happy with this so far, my hair is less dry and frizzy and it appears to be good for my severe eczema.

Pretty good with high quality.

The shower head comes with a hose which clips into my existing riser rail. However due to the heavier head the mounting bracket tends to sag beneath the weight, causing the head to tilt down. I've tried tightening the clamp but may have to invest in another riser rail/clamp. That aside the filtered water is proving to need a lot less cleaning of the scale build up of the old unit.

Very good filter, provide soft water with pressure.

I've actually purchased three of these over the years. I had one for probably ten years and finally needed to replace it as the nubs the water comes out of were brittle and breaking after so long. I recently bought another one for my second bathroom. It is a bit heavy because of the filter in the head, but it's not unusable. It's just something to get used to. I like that it softens the water. It makes it less itchy to shower, especially for my family members with dry skin. The filter is easy to install/replace and I've never had an issue getting replacement filters. There are three settings for the water, I don't usually change it though. A basic shower, a softer more aerated setting, and a hard massaging setting. Overall I like this showerhead a lot and as long as it still exists when the current ones need to be replaced (hopefully another 10 years) I'd buy it again.

Dont know if it had any effevt but the fact that the filters are more expensive than the showerhead+filter makes it useless

Fantastic product. Instant results, we were dealing with heavily chlorinated and hard water. Our hair was dry, brittle, tangled, and our skin felt tight and irritated after showers. Installation was easy, the results were instant. Hair is soft and detangled, skin is soft and comfortable again. The shower head is very heavy from the weight of the cartridge, and it does tend to drop forward, but that's my only complaint. There is another shower head style without a wand if that seems like a big issue for you, I assume it works just as well.

Received this product and had some installation issues (below). However, the filter is easy to install and the whole process is pretty straight forward. Additionally, my sensitive and dry skin is definitely feeling better.Pros- Easy installation process (remove old showerhead and all the old plumbers tape in threads then re-tape with the included teflon tape and screw on this new shower head.)- Definitely helps my sensitive and dry skin. Removes most of the Chlorine in the water.- Filter can be easily installed and changed.- Good shower pressure (even with the flow restricter in). If you need higher pressure, take out the white filter inside the threading of the showerhead.- 5 Settings all worked pretty well and no clogged holes so far.Cons- Threads were a little tight on my piping - had to use two pipe wrenches to tighten (one to hold pipe, one to turn showerhead).- Showerhead was drooping straight down upon install (fixable below). *I WOULD CHECK THIS BEFORE INSTALLATION*- Only about 6-8 inches wide of water spray.- To change the spray settings, you have to hold the showerhead and twist the greyish rubber area.Troubleshooting- If water is leaking form the connection of showerhead and pipe, you need to reinstall the teflon tape (should give the threads a good 2-3 rounds of teflon tape). Then screw the showerhead on tighter (may need pipe wrenches). I had to tighten my showerhead so that the metal ring covered ALL exposed pipe threading before it stopped dripping water.-If the showerhead is drooping and wont stay in place, you need to adjust a rubber ring/gasket inside the showerhead. To access this, you need to twist the ring directly behind the large part of the showerhead counterclockwise, it should be about 3 wide (diameter) and it screws off the showerhead. You may need to use a cloth (pretty rough on the hands). Mine took a good amount of strength to remove, but once removed there is a black rubber gasket that you need to pull out and reseat inside the shower head. This should correct your tilting mechanism. This would probably be easier done before the installation onto the existing piping.

Instructions were good, simple standard shower head installation after the filter mechanism was easily inserted. Matched brushed nickel shower perfectly. I think it will be simple to replace the filter, I kept the instructions but they are probably on the replacement filter when you buy it. Affordable fixture and seems reasonably priced to replace the filter about every 6 months.The difference was truly amazing, more than I imagined it would be. Our local municipal water is known for being particularly "hard" water, (powder detergent clumping, poor aquarium quality) so I experimented with rainwater to rinse my hair. There was enough difference in my hair texture from the rainwater that I investigated shower filters. I knew the name Culligan from special water deliveries for very sensitive laboratory equipment, so I figured they knew plenty about water quality.The first shower I had after installation, I could not believe how soft my skin and hair felt. I have filtered drinking/cooking water for years, and now it disturbs me to think of all the years of skin and hair damage I have suffered in the shower.I have had installation for about 3 weeks, no problems. It has 3-4 different shower settings, but I tend to use just regular spray. I have great water pressure in the first place, and the filter doesn't obstruct at all. In fact, the pulse setting was too hard for me, I don't like a shower that pummels me.I would highly recommend this product as a very affordable solution if you suffer from exposure to hard water. Very inexpensive makeover for practically new hair and skin.