6 Piece hex tip Screwdriver Set (Small Sizes 1.5mm 2mm 2.5mm 3.0mm 4.0mm 5.0mm). ENGINEER dk-02

Well made Japanese tools, It may sound silly, But there is something really satisfying when using a well made hand tool, and these Japanese Made Hex Drivers fit that bill perfectly, Ideal for hobbyists, who are happy to pay that little bit extra for something that is likely going to last a lifetime if looked after.Comfortable in the hand with any of the sharp moulding flashing you can sometimes get, having been cleaned up in the factory. No noticable horrible resin/plastic smell you can get from some of those other cheap no-name branded screwdrivers when you open the package.But this is a set that should last you forever.The only thing that may make this set look a little cheap, is the lettering on the larger of the handles, Not as crisp as the Usual Engineer Branded tools, This is the second of theirs i have bought, the other being a set of crimping pliers, again rather expensive, but do the job they were intended to do perfectly everytime.

This is not quite in the same league as pb swiss. But then again they are a fraction of the cost. They should not be used on very tight fittings, it's not what they're for. They are perfect for fine adjustments where feel is important. Handles are acetate which are actually quite strong. I will use in addition to my wera and pb swiss, not instead.

These are my 'goto' hex drivers for all my 3D printer maintenance that doesn't need extreme torque. The only improvement that I could ask for would be for the bottom half of the storage pouch to be divided into individual pockets for the shank of each tool.

Very well made tools with attractive and well finished traditionally styled handles. Very comfortable to use. Quality Japanese tools. It is a rare thing to find a good quality and affordable set in smaller hex head sizes. This is a good find and to be recommended.

Fairly sturdy, and neatly stored. Did the job, but the fit wasn’t the best, so tighter bolts could potentially round off if not careful.

I have hundreds of hex keys in all shapes and sizes but these are the ones I turn to most often for electronic and 3D printer work. So much more convenient and ergonomic than either T handle or regular L shaped hex keys. Ignore the reviews that say they feel cheap and flimsy, they do a great job so long as you understand their limitations - of course if you need a lot of torque then you want to use a shorter shaft but for most general jobs these are fine.

The transparent handles on the hex drivers tend to make them look a bit cheap and nasty but they are actually reasonably good quality, well made items. Also, being hex the full length of the shaft it's a simple job to grind them back if the tip ends up getting worn.

I needed a 2mm hex Allen driver for biasing a tube amplifier . The shaft of the driver is not insulated but it is sold as an engineering tool and not an electrical tool anyway . The handle is resin cast so will isolate from that. It’s affordable and works for me. Recommended.

They are all bent and uneven, poor quality.But they where 11$ so cheep enough for what they are.

Ideales para acceder a lugares estrechos y profundos con tornillos tipo Allen o exagonales. Me resolvieron un gran problema pues no podía desmontar componentes audio por falta de espacio.

il prodotto si presenta bene nella sua custodia di plastica, la finitura del manico poteva essere migliorata, ottimi per raggiungere viti in posti angusti, il terminale dritto guida la vite con precisione

Je les utilise au travail ils me sont bien pratique surtout la taille 1.5

モニターアームの付属レンチがどこかにいってしまったのでこちらを代用このサイズがぴったりです。ちゃんと使えてよかった。あとお値段安くて助かりました！