SAVITA 3 Sets Thumb Studs, Titanium Screws Replacement Thumb Studs Pocket Blade Screws for Benchmade 535 Bugout (Black)

Didn’t fit the Buck Bantam that I bought them for. Would work on a thinner blade. Seem like good quality, look nice. Bummed they didn’t fit.

Would work great on a small folder probably best for 3 in and under.

The other side of the thumb stud doesn’t have the torx, it’s just a hole. The black pair also didn’t screw into each other. I used the silver pair on a beater knife so I’ll keep ‘em

I used this on a folding Kabar knife that lost its studs. I got it on to stay, but for some reason it won't quite tighten down onto the blade, so it moves a bit. Still works, though, and probably works fine on some other knives.

Idk what people are complaining about. If you want a good product don’t cheap out!! You get what you pay for. That being said it works perfect as a replacement on my 535. Better to have one then to be missing one. I lost mine in the washer but these replacements do the job.

I was very happy with this purchase. I have a Boker rescue folding knife, and somehow I allowed the thumb studs to get loose and fall out. Needless to say, without the thumb stud it becomes much less useable. These studs worked perfectly and got my knife back up and running.

Pretty cheap on quality!

Super simple install with a Torx bit, pliers, and red Loctite.Perfect fit.

What a find i have a few pull open knives or folding knives and these little studs just drill a hole pop the stud in and then screw the other side on and you have a single hand opening knife , wow what find

Machen was sie sollen

First off, only one side of these thumb lugs accommodate a torx fastener (T8). Whereas with the original lugs you can use two T6 fasteners to snug the lug tight, here I used a pair of pliers to hold one side down while I tightened the other with a T8 driver.It's also worth noting that the nominal outer diameter is 2.4mm (measured with generic digital calipers so there's probably some error in that number). That's a little bigger than I expected as I was going to use these for a replacement on a non-535 blade.

Die Verarbeitungsqualität ist super und die Farben sehen auch gut aus, wie auf dem Produktbildern. (Habe das set mit Blau weiß und Silber)Wie bei dem Preis schon zu erwarten war, sind die Schrauben nicht aus Titan und lassen sich in der silbernen Variante leider nicht nach Belieben in andere Farben anodisieren.

The screws are too short for the thickness of the blades I wanted to apply