BRIGHTLINESCross Bars Roof Racks Roof Bars Replacement for 2016-2019 Ford Explorer

Easy to install and fits just as expected

Order arrived quickly. Cross bars were easy to install and fit perfectly. So far so good. Waiting for ski attachments.

Ordered this set of cross bars for an XCargo 20 (one of, if not the largest cargo carrier around). I was a bit concerned about the "100lb" limit, given that the box itself probably already weighed in at 20. We packed it full, took it on a 22hr drive across country and had zero issues with these bars. They never gave any sign of being overloaded (I didn't measure, but it had to have been close), and at speeds of 75+mph. They adjusted well, and took about 15mins to install (the factory allen wrench means you can only get a 1/4 turn or so at a time, so it takes a while. Grab a cordless drill and you can have these on in 5 mins). I did have a problem in that one of the screws came with either a bit broken off in it, or something left from a rock washer that they run them through. It was wedged in there and meant that I was unable to tighten. I informed the seller, and without even seeing a picture (see attached), they shipped a replacement out next day. Can't ask for better service than that!

Well, #1, east to intsall, I had the star bit to take out the temporary screws (cant take them out with the wrench in the package. #2 After reading other reviews I invested in a $3 set of hex head bits for my drill, took 5 minutes to installthe bars. #3 Shame on you guys, the hex head wrench did not fit the adjustment screws, luckly I had a hex head set and found the right size. #4 Listen to this purchasers.... for the back one loosen the adj screws, pull it out and screw in the 4 screws into the bar, THEN take a piece of tape, wrap it around the bar then take off bar, tighten adjustment screws, then reinstall. A. wrong hex heads on adjustment B. Cant tighten adjustment screws after install or you will scratch top of your explorer..C. Get a hex head set for a drill or screws diver and save yourself 1/2 hour and lots of swear words. All and all, its better than buying the same OEM Ford product for $200+ .

Installed this product in 10-15 minutes with ease. It is clearly labeled to notify you of proper orientation and which one is the front/rear. The crossbars themselves are sturdy and metal with the brackets a hard plastic material. After tightening them down, I didn't notice any cracks in the plastic from too much torque or pressure. Since it's only been a week with no rain, I will have to wait and see if there are any leaks, but right now it seems like it would hold up. I may go back and apply plumbing tape to the Allen bolts if my concerns grow. However, the plastic Torx bolts didn't leak so we will have to wait and see. The bars themselves are thinner and more aerodynamic than previous ones I've owned such as Volkswagen and should not produce much wind noise. The bars should also fit most attachments with ease.