Tenda AX3000 Mesh WiFi 6 System Nova MX12-7000 sq.ft WiFi Coverage - - 1.7 GHz Quad-Core CPU - Dual-Band Mesh Network for 160+ Devices - 3 Gigabit Ports per Unit - 3-Pack

I love just this item since I bought it a friend of mine bought it and he told me about it and I tried it out in his house and my tablet and my phone was running pretty fast with it even though he has fast internet but that thing went a little bit higher than what it's supposed to be especially for my house when I bought it I have what the basic internet the lowest one that you can have anyway I bought this thing and it helps a lot I got good internet now my security cameras are running from it so they work very well with it the darn thing comes with three of them so you can connect them in three spots of the house you know so you have coverage everywhere in the house wherever you're at even in your basement and if you have a close to the walls that it hits the outside of the house you have internet going to the outside too so if you and your yard you receive it really good signal out there this was a good purchase for me 👍🏼👍🏼

My house is on the 3rd floor and the modem is on the 1st floor while using AT&T fiber. So the wifi signal is weak on the 3rd floor.Download pc speed test under 100mpbs on the 3rd floor and about 400mpbs on the 2nd floor. 1st floor is 900mpbs...But after installing tenda AX3000 Mesh MX12, 3rd floor is 450mpbs, 2nd floor is 900mpbs or more. comes outHowever, there is a big difference between the speed test and the file download speed. After installing the mesh, the file download speed is many improvements very satisfied....However, with a cell phone, the speed test comes out to about 900mpbs on the 1stfloor and 880mpbs 2nd floor, and 450mpbs 3rd floor

it's a shame because wireless range and quality is really good and the interface isn't bad, however I'm not sure if it's bad hardware or bad firmware but these things are ridiculously and infuriatingly unreliable. it's not bad with a capital B, it's bad with a capital BAD.first, I have one unit that just randomly decides to disconnect itself from the network for no particular reason. literally. it's in my office room connected to nothing but my nas that sits idle 99% of the time as well as my office desktop and network printer which both are off 99% of the time. periodically I'll try to access the nas or Windows will give me an alert for file history being disconnected too long and I'll open the router portal and that unit will be grayed out on the tree. sure enough go into the office and the light is blinking green. power cycling the unit fixes it but this happens SEVERAL TIMES EVERY SINGLE DAY.second, the 2 secondary units will just crash or something when faced with too much traffic. how much is too much? a single 1080p youtube video apparently, in some cases. ill be watching a video, then suddenly the wifi will drop out, i look over and the unit is blinking red. after a bit it will reset itself and reconnect, but this is still 2-3 minutes after failure so its not a short quick interruption. same for the other one, i tried to hook up and run a pihole (network wide adblocker) just to try it out and that unit would CONSTANTLY crash 2-3 times AN HOUR due to the entire network having to be routed through that unit to go through the raspberry pi.finally, the primary unit will also itself just randomly decide "im out" and do the blinking red light. this kills the entire network for the house because even if the other 2 units (by some miracle) are fully functional at the time because nothing can connect to the local network anyway. this is the rarest issue of the 3, but still shouldnt happen in the first place.note that this is with an entirely ethernet backhauled setup too, no wireless to wireless bridging, which makes this all the more damning.before i bought the mx12 ive been running a mishmash of a couple entirely different routers (a dlink and 2 tplinks) that all just said the same SSID and password and disabling dhcp on all but one of them, effectively meshing them. i ran that setup for over 5 years, and it worked perfectly. seriously, i had probably 95-98% uptime that entire time, there were almost no problems ever. even going room to room the handoff between routers was seamless. i only upgraded because i wanted wifi6 and i didnt want to spend 300-400 bucks on multiple mid tier routers. clearly i should have.

Awesome mesh router with fantastic wifi coverage.Just beware of the Cons:Pros:1. Easy setup2. Fantastic WiFi coverage.3. Great PriceCons:1. Guest WiFi always disables after a hardware reboot or if the Auto System Maintenance nightly reboot option is active. This appears to be a firmware issue. Phone support offered no solution. No update from Tenda email support (yet).12/15/23 Update on Con1 below. Fixed!2. VPN does not support built-in OpenVPN client for popular VPN providers like NordVPN3. Phone based support is limited to basic troubleshooting. Then you have to email support.12/15/23 Update. Thank you Tenda support! Posting this review prompted Tenda replying back to Con1.12/15/23 Update - Changed Review from 3 star to 4 star.12/15/23 Update to Cons 1: Under Guest WiFi there is an option for "Validity". 4h/8h/Always. This option is not for DHCP lease time but how long the Guest WiFi will stay on / up an running. I have personally never seen a switch on a router for WiFi up time. Change this option to "Always" and the Wifi will always be up and running.