PGFUN The Latest Upgraded Anti-roll 3D Touch Probe Waterproof Edge Finder

Specification:
Power: DC5-24V
3 NPN-NO Wiring: Red-VCC (DC5-24V power), Yellow: IO/ Signal Output, Black- GND(DCM)
Repeatability Accuracy: 0.01 mm/ 0.0004 in.
Feedrate: 50-200 mm/min.
Approach Direction: ±X, ±Y, +Z.
Over Travel Protection Distance: X- ± 4mm/0.16 in, Y- ±4mm/ 0.16 in, Z- 2mm/ 0.08 in.
Lifetime: > 3 million triggers.
Trigger Force: XY- 0.5-0.82 N, Y- 2.7N.
Application: theoretically it can work with MACH3, Mach4, Dynamotion, LiNUXCNC, UCCNC, Centroid CNC, or any other CNC control software
Package Include: CNC touh probe x 1, cable x 1, allen wrench x 1, probe tip x 1, wire connector pack x 1 (to solve the lack of control board wiring ports and extend wire).

Software Recommendation
Probe Wizard or ProbeIt are recommended for Mach3, and GRBLGRU is recommended for GRBL.

FAQs:
Q1: Need to turn on the spindle speed?
A1: Please do not, or it may cause measurement error.

Q2: Why is the concentricity different when the probe is installed?
A2: Because the low-accuracy spring collet can't guarantee 100% positive position. After each installation of the probe, even if the concentricity is adjusted to 10 μm, there will still be deviations when the probe is re-installed. So it is best to use a AAA /UP or higher accuracy ER spring collect (run-out tolerance <0.0002") for your chuck. It is recommended to use a high-precision gauge to check the concentricity after installing the chuck.

Q3: i need a NC touch probe, what should i do?
A3: we added the NPN-NC touch probe, you can buy the right wiring version for the machine now.

Q4: Does this touch probe work for the non-conductive material like acrylic?
A4: This is a mechanical probe, it identifies and transmits the signal by physical contact, do not worry about the conductivity of the material.

CNC 3D Touch Probe Upgraded XYZ Axis Anti-roll Edge Finder Waterproof 3 Coordinate Measuring Sensor Kit with 6mm Shank & 6.5 Ft Cable, Compatible with Mach3 (Edge Finder-NO)

Description

Common Questions