Black Conductive Shielding Paint

After shaking up, it's a nice and thick shielding paint that spreads really well. Shielding capabilities seem really effective. I didn't realize it was only 1oz (because I didn't read), but that was PLENTY for two coats on two guitars. Do note that the brush is cheap and fell apart before I could finish the first guitar. Get a good hobby paint brush with a long handle. Also, don't spill it because it's just as pervasive as anti-seize; it gets everywhere and spreads like a virus. Good when your painting; bad when you are cleaning.

This is a water-based paint that is very easy to apply and dries nice and evenly. I put three coats on to make sure that I was blocking the most interference I could from the guitars electronics. I tried taping first but had poor results. I applied this to my electronics cavity in my Stratocaster, Les Paul, and my Paul Reed Smith guitars with great success. Would buy it again.

Applied 3 coats and got .001 on the reader so its not 100% effective as copper shielding, but it is much easier to apply and still works well enough to make a good circuit. One thing though, this stuff (at least my jar) literally STINKS. I can't even describe the smell, like sulfur and a retirement home..... luckily it goes away after it fully dries. It is a bit expensive, but this is enough to do a few guitars for sure.

I have a favorite guitar that was perfect in every way other than its propensity for humming and buzzing. Way more than other similar guitars, even after redoing the wiring, pots, and jack. I decided to give this a chance before taking it to a professional. The control cavity was already coated, but I went ahead and painted it a second time. The pickup cavities were not painted at all, so I got both with two coats, let it all dry overnight. The next morning, I buttoned everything back up and all of the hum was gone. Not until I was inches away from my monitor could I hear anything at all. This is great stuff, I'm gonna buy more and shield some more guitars that have been problematic with noise in the past.

A+++

Had two guitars with buzzing for years. Just found out about shielding a guitar and bought this product. So easy to use, easy instructions and easy cleanup. I was able to put 3 coats on a 1 humbucker pickup guitar( 1 pick up cavity and back cavity) and 2 coats on a 2 humbucker pick up guitar( 2 pick up cavities and back cavity). Amazing product, Finally the buzz is gone.

Will be ordering more, it goes on nice spreads real good it’s black for sure I was able to do 4 coats on one guitar and 2 coats on another and it works really good I had the copper tape before I took it out and painted it with this I also painted over it with black and did a clear coat over it so it ain’t going nowhere and still works great no noise

Easier than using copper and looks clean. Good product