Coffee PLA 3D Printer Filament 1.75mm, Dimensional Accuracy +/- 0.02 mm,2.2 LBS (1KG) Spool, DAZZLE LIGHT PLA Filament

UPDATE:I have now used almost 70 rolls of this exact item (I make and sell certain items) and of all the filaments I have tried this one has been the most consistent and trouble free to date. Pricing does range but it is typically still less than others available and the color is perfect for my needs.I have ordered this PLA many times and not once have I had a single issue with any of my prints. No clogging or stringing on my CR-10's I have. I use settings of 205 degrees and 50 degree heated bed. The coffee color that I purchase is a real nice light color compared to the other ones I have seen and tried(imagine coffee with cream).

I'm not a rookie when it comes to 3D printing, I own three 3D printers (CR-10s, Ender 3 & Anycubic I3 Mega) and have printed hundreds of things (successfully). Every once in awhile I will walk on the wild side and take a risk with a new filament, and every once in awhile I'll get burned. This is one such case.This filament clogged my nozzle and hot end so badly that I had to do an atomic pull while I had the hot end at 250c!!I had my hot end printing at 215c when the clog happened (had to bump the temperature up because of very poor layering at 205c). At first I wasn't ready to blame it all on the filament I thought my nozzle may have contributed to the clog so I changed out the nozzle and started the print over. This time it didn't even go as far as the first time (never got the first full layer down) and the nozzle and hot end clogged again!!JUNK - You get what you pay for...this will be going back.

I have over 2 years experience in 3D printing and have used many brands of filament. I rarely run into filament that is a problem but this filament clogged twice and appears that it’s about to clog again! I do not recommend this brand. It may have been a bad batch but in that case they have an issue with quality control.

I bought 3 colors, Blue, Coffee and Transparent. Have not used the Transparent yet. The Blue works okay. But the Coffee is garbage. I tried several different settings and it just wont bind to its self....

I had the same result as "Slvrbllt44". I have tried this filament in both of my printers (Maker Select and Ender 3) and experienced severe nozzle clogging in both of them. during my last attempt, I had the extrusion temperature set to 220 Deg. C just to get it to extrude somewhat normally and had intermittent issue through the early stages of the print and then failure from another clog. This is terrible filament and will be returned!

Prints smooth, nice color.

I have purchased filament from this brand before and they were okay, but this filament is not a okay at all. it clogs badly and there is not way to go around it with higher temps. I lost most of this spool with unfinished prints due to clogging.

Had many problem to get good adhesion. Had to print at top temp to prevent under extrusion.