Phoenix V-Belt Pulley - 1in. Bore, 4in. Outside Dia. c

Looked everywhere local for the same thing. They all wanted a ridiculous amount of money for it. This feels well made and works great. Would definitely buy again.

Excellent quality.

It fit

I recently did an engine swap on my new to me Troybilt Tomahawk chipper. I went from the original 8hp Briggs to a Honda GX390(13hp) & needed to find a pulley that would adapt & this was it. It seems of good quality & balence. I subtracted a star because one of the two Allen set screws was a little sloppy for the Allen wrench & so I will replace them both with ones from my trusty local hardware shop for better quality. Now, the chipper is a "BEAST"!

Exactly as described, just the pulley I needed when putting a pushmower motor (Briggs off of a Craftsman) on my belt-driven brush trimmer (DR).

I restore kee lawn mowers and this pulley works great as a replacement for the blade spindle.

I replaced a the main drive pulley on my chipper/shredder, honestly I just expected it to fit close. I installed this as a one for one, inside diameter was dead on. The side flanges are as beefy as the original which, is over 30 years old.It's nice when parts are manufactured and fit as advertised.

The pulley was good quality and fit my application great. I used it to rebuild an old chipper. I was concerned it might not be strong enough or would not line up. However it works fine.