24KF Contemporary Upholstered Tufted Leisure Chair Accent Chair, Sofa Lounge Club Round Chair for Living Room Hotel with 3 Pillows 7022-Dark Gray

I love this chair! It was easy to assemble, not as small as the picture! Big butts can sit in it! It comes with three pillows, I added the center pillow myself💋

The color is beautiful and it’s perfect for one.

So, I purchased this chair with the expectation that it was a large chair. It's extremely cute, but sits really low. Wish it had more height. You can barely see the chair in the room. Just disappointed because the chair appeared bigger on the site. It would be more of a hassle to disassemble the chair and return it. That burden would be on my husband and I didn't want to put him through it.

I really love it🥹..easy to build, really nice !I have no regrets 💐

Firstly, if you're assembling this, put the feet on the back first, but before you fully tighten the bolts for the legs, lean the whole back against a wall. Level out the chair back against the wall, and then tighten the legs. If you don't own a level, just look at the bottom of the chair back, and make sure it runs parallel with the floor. Tightening the back legs up must be done before attaching the seat base. Next, you should loosely install the feet to the base. Then, you should use a center bolt position to attach the base to the back. Set the whole thing on level ground a carpet type surface isn't recommended). These steps will allow all of the feet to touch the ground. Install the remaining 5 bolts from the base to the chair back. I would start to tighten one center bolt, and then move to either the left or right side bolts. Move from one side to the other as you tighten the bolts, or it will pull one side very tight. That will cause the other side to lift up slightly, and it'll be unbalanced. Once both sides are reasonably tight, you can fully tighten everything up. The chair should sit on all four legs. Now, this thing makes for a pretty good guitar chair IF you have short legs. It doesn't have arms to get in the way. Your thighs will sit relatively level. You can store spare cables, picks, capo's, spare strings, et cetera...all in the base of the chair. By adding some weight, I know it can support at least 300 pounds if it's assembled correctly. It doesn't feel like it's going to break or wobble at that weight. For me and my purpose, it was a good choice. The only thing I think will fail, with a fair bit of use, is the mechanism and attachment points for the tilting of the base. It's cheaper plate metal, hinges and screws.

Super cute goes right along with my two piece set!

I can't believe how small this chair is for the amount of money you guys charged for it what a rip off.

Nice. But a bit lower to the ground than I expected. It’s a nice piece. But if my mind was thinking I would’ve measured & just went with the bigger, higher one.