Plasma Cutter, Non-Touch Pilot Arc 50Amps Non-High Frequency Plasma Cutting Machine with Large LCD Display 110/220V Dual Voltage IGBT Inverter 4/5 Inch Max Cut 2T/4T, for Beginners DIY

Absolutely amazing, especially for the price. I have 20 to 30 hours of cutting 3/16 steel plate under my bent with this machine. I have ony used it on 220v thus far, i have not rried the 110v adapter.

Highly recommend worked better than expected

The npt holes on the regulator and included fittings are of no use. I tried ten plus wraps with the included thread sealing tape and it still wouldn’t take up enough of the gap to seal. I even tried some higher quality thread tape and loctite thread sealant with no luck. I bought a separate regulator and fittings from Harbor Freight, which had no leaks after installing the first time.

Great machine, good price. make sure u keep the regulator on the machine and your compressor under 80psi. notice it says pt-31 style consumables but none appear to fit because the electrode included with the machine is threaded while others appear smooth... kind of a bummer after the only included consumable finally melted during use (been using it for a while). Will advertise these on TIKTOK if possible. great machine. please reach out to me so I can help other customers find consumable tips, electrodes, rings, and caps. Lets keep this a 5 Star Product and Provide some customer service please.

Bought this plasma cutter to pair with a cnc plasma table. I have no cnc experience and I didn’t want to spend $4000 on another brand not knowing if this cnc venture would work out. It has exceeded my expectations so far. I haven’t cut anything really thick so far . I’ve cut up to 1/4” and it handled it with no problem. Clean dry air is a must.

I can't give more than 3 stars here. According to the instructions you can use 110V using the inbox adapter. Every time I go to cut it trips out the outlet. I changed the outlet (it was old GFI) still tripped it. So, my project got bigger as I am finally installing a sub panel in the garage to handle this.

This item is ok not great. I try to cut 3/16 stock metal with it, didn't do good with 110v. So I ran a 220v circuit and it did well. So, if you want a clean cut with a 3/16 or above you will have to use 220v otherwise it gonna chop real ugly.

Poor quality consumables, very over rated in power and capability. Clean metal on 240v and air through a 3 stage air dryer fed by an engine drive compressor and the plasma cutter struggles to cut through 3/16 plate yet they claim it can do 5/8 on 240v. Wouldn’t recommend this machine to anyone that needed to cut anything more than 18 gauge sheet metal.