Creality Ender 3 V3 SE Hotend Kit, Original Ender 3 V3 SE Extruder Hotend Heater Block Set Assembled Print Head Kit Heat Resistance 3D Printer Accessories Replacement Kit

Upgraded my Ender 3 V3 KE with the official Creality ceramic hotend kit and I’m seriously impressed. The ceramic heating block is fast and stable, reaching 200 °C in just 40 seconds with consistent, even temperature. Thanks to the copper‑titanium alloy heat break, thermal creep is minimal—even at 300 °C, prints stay sharp and controlled.I noticed improved filament flow and print detail—PLA, PETG, ABS, TPU (95A) and even ASA run smoothly now. Setup was easy with pre-assembled heater, thermistor, silicon sock, and nozzle. Using stock firmware, performance matched up perfectly.Highly recommend if you want faster heats, reliability up to 500 mm/s speeds, and cleaner prints. A solid upgrade that delivered exactly what Creality promised—5/5!

Ths worked great and was easy to install, completely assembled and ready to go. Just make sure you have a good cooling fan for the heatsink. it is identical to my original on Ender 3 V2 SE. All parts and plugs fit perfectly.

This is an exact replacement for the hot end for the creality ender 3 v3 ke. Works great.

Bought the hotend for the ender 3 V3 SE and it works great! Only thing is the nozzle didn’t come tightened and it didn’t tell you to tighten it after installing so plastic leaked out all over it but it cleaned up easy and after tightening it worked great. Make sure you run the leveling process after installing. Also tighten it at printing temperature.

During an attempt to remove a clogged nozzle, the nozzle snapped in the heat block (yes I heated it first). I needed a replacement heat block but the one on the V3 SE is unique. None of the others looked the same. This one is identical to og. It also is already wired. It comes with a new nozzle already installed, the plastic tube, radiator, and two mounting screws (which was good because they got bent in the aforementioned incident). It was pretty easy to switch out but I recommend watching a YouTube tutorial. The connectors are glued to the board but you can pick the glue off. And carefully disconnect connectors.I took a lot of pics while I switched it out and also opened up the extruder to make sure all was well there too. This is the Sprite hotend. But it's different than other sprites. That said, tutorials on the Sprite will do you fine. But I dont think other sprite hotends will work with the SE model though. They are shapped quite differently in key areas.Im irritated that the nozzle broke off so easy though. I've only had the SE a week. I think the OG heat block was drilled badly or something. Don't know if this holds true for the replacment but it's not like there are other options either way.

I had my first hot end mega jam and picked this up for my ender 3 v3 plus. It is a direct replacement and great quality. I was able to get my printer up and running right after installation. It cones with thermal compound so you will not need to grab any extra.

I bought this for my 3d printer as a spare, in September, but I did not need it until now. When I opened it to install it, the ceramic was cracked and once installed it did not work. Very disappointed. As now I have to wait and order another before I continue printing this affects my whole business.

Item fit perfectly and worked great.