Under Cabinet Lighting, LED Motion Sensor Light Indoor, 2200mAh USB Rechargeable Closet Lights Battery Operated, Stick On Magnetic Wireless Dimmable Under Counter Lights for Kitchen, Stairs (2 Pack)

Update 20Feb2025: The light lasted almost 6 months before dying (completely dead) on the first complete charge for my application. Not bad. Everything is still well stuck, nothing has fallen off. I have since mounted one each of these in a couple of Ikea PAX wardrobe cabinets and they work great in that application to provide just enough to see what is going on in a dark or dim environment in our bedroom.Product purchased was the 13-inch, white, two pack. I would definitely buy these again if needed.I was surprised, when I measured this light, that it exceeds its specs. It is pretty rare, in my experience, with battery operated products to do so on Amazon.I fully charged one light. Then let it run at its brightest setting until it died. It lasted a total of 11 hours and 6 minutes. Then I charged it to full from that state. It took 5 hours and 6 minutes. Total capacity to charge was 3325mAh. I'd say that for the first 9 hours or so it was at the full bright setting and at about the 9 hour mark it dimmed to about the 50% setting (still very usable in my corner cabinet use case) for the last two hours before shutting down completely.When the light is activated by motion, it stays on for about 20 seconds. It stays on longer if motion keeps triggering it until the motion stops.The light measures 13 1/16 inches long and 1 3/4 inches wide and using the sticky magnetic plates for mounting, the total thickness is 1/2 inch (about 7/16 inches without the metal plate). The two metal plates that you stick to your surface are 2 5/16 by 1 inches.There is pretty small hole in the metal plate that you could theoretically use to mount with a screw but the metal is pretty thin and the hole is only 1/6 inch wide but could be very easily drilled out wider if needed. Since it is so thin, you would definitely need a flat head screw to try and get the screw head flush with the plate. You could always use a similar or smaller sized plate of your own making as well. The plate is not a magnet, just magnetic. The magnets are within the light spaced about 9.5 inches apart, so you can stick these on magnetic surfaces which opens up all kinds of other applications for these). A couple of flat head screw heads or washers were all it took to support the light's weight horizontally, but they would not do so vertically as the light's back surface is metal (aluminum it seems) and so it slides off the screw heads in that position.I've mounted one each of these vertically in two corner cabinets. So far everything is staying stuck pretty well. Will report back if/when they fall off/unstick.Photos show a USB meter while charging (red light) and when fully charged (green light). The motion sensor bubble lights red while charging and green when complete. Two other phots show the inside of the cabinet during daytime, one with light off and the other with light on. I adjusted the photos' brightness to match what I see with my eyes, to give a realistic representation of before and after brightness levels. Light is mounted vertically on the right wall as shown in last photo (not adjusted for perceived brightness).One 8 inch USB-A to USB-C cable is included that has two USB-C connectors so you could charge two lights at a time. No power adapter is supplied.There are four switch settings: On (always on), Off (always off), Moon Symbol (only motion activates in dark environments) and a Sun symbol (motion activation active even in iight environments). Another button controls brightness levels a quick press cycles to the next brightness level. Brightness levels are stated as 100%, 75% and 50%. There is a fourth level that seems to be a duplication of the 50% level. Not sure what that is supposed to be. I could not get the Night mode to work. Even when shining a bright LED flashlight at the motion sensor, it still motion activated, duplicating the behavior of the Daylight setting (which is what I use in my cabinets). All 4 of my lights behaved the same way, so I doubt this is just a defect. You can also set the light brightness by pressing and holding the brightness button and releasing at the desired brightness level from 10% to 100%. The light will remember your brightness setting.

this is just what we needed!We had a battery operated light with a manual on/off switch in our dark lower cabinet which worked fine; if you remembered to turn it off!This turns on and off by itself and gives plenty of light for a small space.USB recharge is a great feature but we haven't had to recharge this in the 6 months its been in use.Very happy

I've been using this light for some time now and I love it. Very slim and light weight. One of them I use it in my closet (maybe lights up 1-2 times a day). The battery lasts for very long time and I charged only once so far. The other one, I put it under kitchen island where our cat feeds. The light turns on very often (maybe 20 times a day?) but the battery lasts for a week or two. Motion-detecting switch is so helpful. I recommend this light to anyone.

This is a really nice light. I wanted it for the bathroom that is attached to my bedroom. I didn't want to have to put on a light to find something while my wife was sleeping, so I thought this would do the trick. Plus, my cat goes in to the bathroom several times during the night to climb up on the sink and get a drink or do other nocturnal kitty things. He's 18, and I thought he could use a bit of light to help him. But it is really just too bright, even on the lowest setting (hence the 4 stars). It would be better for a kitchen or hallway I'm sure, somewhere with a barrier between the light and the bed.

I didn't expect this small light to be so bright. I purchased it as additional light for over a desk in a dark area in my craft room, it lights the area up perfectly. I love that I can choose the brightness level and how lightweight the light is. It was very easy to install, using a strong adhesive attached to a metal plate that you put on your wall (or in my case on the underside of a shelf) and the light has a magnet in it which then is attracted to the metal. I've had it up for about a week and have used it for 3-4 hours every night and I still haven't needed to recharge it from how it came out of the box.

We have a dark butler's panty with no electrical nearby. See first picture. The second picture is after the light was installed. We have it set to be motion activated. The battery has lasted well over a week (compared to previous one - batteries discharged after one week). Easy installation. Quick USB charge. The light has weight and feels well made (not all plastic). Two lights come in the box and I am trying to figure out where to put the second one!

We have had these for over a year, we use them in the pantry of our travel trailer, we mainly use the motion sensor mode. The light softly turns on when the cabinet doors are opened. They are easy to remove from the magnetic base and charge. They have never come off the magnet, not even during travel.

I know I’m getting older when it’s harder to see in a dim lit area. I bought 2 sets to try out. I just ordered 2 more sets. Easy to set up, quick to charge, and the motion detection is great. I don’t have to fumble around for the switch. I can now easily see under my cabinets, which is less eye strain.