eXtremeRate Clear Black DIY Housing Shell for Nintendo Switch Console, Replacement Faceplate Front Frame for Nintendo Switch Console w/Volume Up Down Power Buttons - Console NOT Included

The shell looks great, no complaints there! Just a word of warning, the front shell is a lot more labor intensive than the back shells or joycons. I learn this the hard way 😅

Everything seems about perfect for me. I actually used the included screwdriver(s), even though I already have a few sets. I watched a video on YouTube on my tablet while I did the installation. I had to rewind and pause the video a couple times but I just took my time and didn’t break anything. I also have years of experience disassembling electronics so I’m sure that might have helped. People who complain about the screwdrivers don’t understand that you have to apply pressure while unscrewing those screws or they most likely will strip. The only part that confused me was which way to put the power button in. It seems like I got it though. The switch looks great and some people think it’s a limited edition. I used a blow dryer to heat up the edges of the screen and used the included suction cup to pull it out. Once again, you have to take your time. This is really a must if you have replaced the backplate because it looks kinda dumb just to replace the backplate and the front plate is still black. I ordered the front and back at the same time. It takes a little over an hour to complete. The only real problem was the kickstand.: I had to soak it in hot water from my Keurig to soften it up so I could straighten it out because it was warped, but after I was done it was fine. Both kits included a whole set a screws and a really nice screwdriver(s).

An awesome way to customise your switch, it's so easy to swap the back plate but only someone commited will swap the front half of a switch

Die transparente Front von eXtremeRate passt wie angegossen auf meine Switch. Ich konnte keinen Unterschied zum Original feststellen – super Qualität und absolut passgenau. Optisch ein echter Hingucker! Einziger Hinweis: Für den Digitizer musste ich neues Klebeband besorgen. Mein Verbesserungsvorschlag an den Hersteller: Bitte künftig auf allen vier Seiten der Front dort, wo der Digitizer aufliegt, einen schmalen Streifen 3M-Klebeband vormontieren. Dann wäre das Set absolut rund!

stom koste me heel veel geld