CrealityOfficial 3D Printer Adhesive Stick Warping Reducing Glue Stick for Hot Bed 3D Printer Bed - PVP Solid 3D Print Glue Stick for PLA/ABS/PETG/PC/PA/TPU (Pack of 1)

My prints kept failing before using this product, and warping would often occur. After using this glue however, almost every single one of my prints has successfully printed, with little to no warping at all. It’s an absolutely brilliant product, worth every penny!

Works well on my Tina 2.

My Enders V3 SE didn't have any suspension so anything was an improvement. I removed plastic supports and replaced with these noting one is shorter than the others for back-left where theelectrical connections are. No fitting instructions so search Youtube and level the bed again afterwards. Mine was quite unven and had to adjust the bed screws until almost level by inserting something between the bed and ganry to check a consistent distance and adjusting bed screws. Afterwards ran the leveling program tofine tune.

I swapped out my old yellow springs for these silicone mounts, and it was a breeze—took me 10 minutes, no tools needed. My Ender 3 V2 bed is now perfectly level, no wobble, and my prints stick like a dream. These things are heat-resistant, super sturdy, and just make 3D printing so much easier. If you’re tired of constantly re-leveling your bed, these are a no-brainer.

Fitted to the original, basic Ender 3.These were simple to fit. I followed a video just to make sure.The short one is supposed to be that way and fits with the bed heater bracket.There is one model that the short one doesn't suit, but that is stated in the listing. Just read & check your model.Once fitted, adjustments seem easier, finer and definitely more stable.I can now go back to the printer and just print away. It doesn't move any more.I'm sure it will do over time, but the stock springs and the yellow 'upgrades' both require constant levelling.What's more, they're cheap.

Sadly these do not work with the Creality Ender 3 V3 SE, They are just a little too small and wont clamp onto a Creality Glass Bed and the Bed Plate.

For something so cheap and simple this is an amazing upgrade.Bought for an Ender 3 S1 Pro, unwind the large plastic spring adjusters until they fall of. Lift up the bed and remove the springs and swap each for an orange rubber spacer. Then again spin the adjuster wheels until they stop. Simple to do and literally takes 5min.Now when auto leveling it always all green with barely any change each time.After reading the reviews I bought the double pack as it appears the S1 needs 4 equal hight spacers and not the 3&1 you get with the bag of 4.

The best 3D printer glue!