bluedery Starlink Mini Magnetic Roof Mount, Starlink Mounting Kit for Starlink Internet Satellite, 12 Magnetic Bases, Starlink Mount for RV Roof,Car, Compatible with Starlink Standard Mini(V4) Dish

It arrived quickly and I was excited to try it out. It comes with everything required but there is some minor assembly.The instructions make it appear as if the magnets are installed alternating big/small/big/small but when you turn the instructions over for the next step the magnets are visualized with the bigger magnets towards the outside and the smaller magnets towards the inside.I followed the instructions, moving the magnets to match the later steps but when I picked it up the mini fell off. I must have missed a step. Unfortunately the set screws that secure the mounting plate to the mini end up below the brackets that hold the magnets so I disassembled most of it to try again.This time I ensured the set screws were properly seated and I tightened them as far as I was comfortable turning them into the mini using a screwdriver. Fully assembled it a second time and as soon as I picked it up the mini fell off again! You can see where the 2.5M set screws are supposed to go into the factory slots on the bottom of the mini and it appeared like they were but with movement the mounting plate flexes and that is enough so the set screws are not enough to hold the mini in place. You can see where the the set screws slid out of the slot on the bottom of the mini and scraped the surface of the mini in the attached photo.The instructions are labeled Starlink Gen 3 but the instructions clearly reference the Starlink mini so I'm pretty sure I ordered and received the right one. There are extra parts left over so perhaps it works better on the gen 3 Starlink.On my next attempt I very carefully jammed the mounting plate as far into the mini as I could and spent time ensuring the set screws were actually set into the mini's bottom. This time it worked and the bracket held onto the mini.The hood of my car apparently isn't magnetic so I had to use the trunk and the roof has a large sunroof so it's not a good alternative. It's a little too big for my trunk. The magnets did feel like they would hold it fairly well.I don't like that you have to disassemble the majority of it using an allen key, wrench and a screwdriver just to get it off the mini. It's unfortunate the set screws are located under the brackets.

Great quality and heavy duty construction. The magnets are nicely covered so they don't scratch the paint. The hardware is top quality stainless. The straps could be heavier but they seem sufficient and are nicely powered coated. Would recommend this, yes.

I think this will hold well for stationary use but mobile use I would need to test further. The magnets may have had more holding power before the rubber casing on them but even paint will reduce a magnets hold.It assembled well and will do it's job, but for mobile (driving down the road at highway speeds) I would prefer to add extra strapping and connections.

Lucky there's a bunch of magnets, because these are nowhere near as strong as similar mounts. They'll probably hold, but only because there's so many of them.I got a roof-mounted lightbar, here, that had much better magnet mounts. I couldn't pull them off without sliding them. There were only 4 connection points on that one, and yet it was much more securely mounted. Also, these mounts by themselves are much stronger than the cheap ones this thing comes with. Even these single-magnet mounts make a stronger bond than the 6 magnets total that make up each one of this products magnetic pads.The rest of this is just some aluminum pieces you could probably bend or drill at home, so you might be better off making your own and sourcing the magnets elsewhere.Especially for that price. Wowsa.

Attaches easily and provides just the right amount of adjustment. Strong material and makes mounting easy. The included parts and tools is a nice plus. - good magnetic attach