ROCCS 4X Tie Down Anchor Truck Bed Side Wall Anchors for 07-20 Chevy Silverdo/Sierra,15-20 Chevy Colorado/Canyon,Trucks Cargo

This is the 2nd set of these bed anchors that I’ve purchased for my GMC Canyon. They do the job great & look good. Much less than the manufacturers product. Just a hint when installing the anchor: tie a piece of twine (a shoelace) thru the anchor & pull towards you strongly, as you are tightening the bolt. Pull hard, . . . that will hold the backside of the anchor plate as you tighten it. It was a piece of cake to do. Worked for me, great product.

I looked at and purchased several styles and found these looked the best and are made for my 2016 GMC Canyon. The most difficult part of the installation was removing the rubber plugs in the wall of the bed because I was dealing with a spray in bed liner that covered them. YouTube helped with that. You use a box cutter to cut carefully around the plugs of choice, cut a slice in the center, push a screwdriver into the silt and work the plug out. The installation of the ROCCS tie downs is easy. I did paint the heads of the stainless steel bolts black to match. That would be my only criticism. They should have supplied black bolts since many trucks have spray in bed liners. Good product, works well.

Installation is a little tricky. A ratcheting 13mm is a must! Very solid once installed. Also, a ton less money than the factory option. This was my second set because they come in 4s and the truck has 9. I'll just have to do without the center one in the front of the bed. Not a big deal

Installs easily, probably about as strong as what they are connecting to, because it's really only relatively thin sheet metal. Pretty low profile so they don't get caught on stuff but they are big enough to get a standard "S" hook ratchet strap onto. Haven't tested them too strenuously yet but they certainly are upgrade over just trying to get a hook into the open hole in the side of the bed, which you can only do if you have a hook, now I can use rope, too. Installed on a 2009 Silverado 2500 HS short bed with sprayed in bed liner.

The installation is very easy, cast Aluminum tie-down, back plate is steel.A self adhesive foam seal is supplied to limit Aluminum contact with steel.One note: this product is made in China.I wish the product was packaged in a 6 pack (or 3 pack), which would match the # of available openings on a short box Silverado.

A little difficult to install. Once you get the hang of it, it was not problem

I have a 2007 Silverado with the 6.f ft bed with sprayed on Bed Liner, there are four fixed rings in each corner at the base and four holes at the top of the wall above the fixed rings, I had to grind down each to the anchors considerably to get them to fit into the holes on my truck, they will work great, just some extra effort to get them installed securely

Hold every bit of the weight as advertised and were fairly easy to install. Has durable coating that should help these to last longer than my truck.

good products