🚀 Elevate Your Tire Game with Ease!
The VALVE STEM ALUM 8MM SIL is a right-angle replacement valve stem designed for easy tire inflation on dual disc wheels. Its 90-degree bend allows for hassle-free access, while the lightweight aluminum construction minimizes weight. This short valve stem is specifically tailored for rear wheels, making it an essential upgrade for any performance-focused vehicle.
M**.
Aluminum nut strips easily. O-ring looks questinable.
The valve itself looks well made. The finish looks much better than the photos. Just check the size. Not all wheels have 8mm valve holes - 11.3mm is more common.The problem is that the aluminum nut stripped under light tension the first time I tried to install the valve on my motorcycle's cast rim. I reused a stainless nut from the old valve and it's holding fine.I was not sure if the O-ring on the valve would be enough to prevent a leak over time, so I used JB Weld to coat the valve stem, nut, and the rim from the inside to make it leak-proof. JB Weld may crack over time from the stress applied to the valve by air pump chuck, etc., so I applied a thin coat of Shoe Goo over it.Two stars because of the modifications I had to perform as described above.
E**.
Five Stars
Everything fine
L**S
Two Stars
to small the base !!Thanks LuKs
A**R
Poor Quality
As other buys have stated, these are of very poor quality. Add a little extra and get a much better quality pair in these. They're worth the hole you'll have to expand, and they'll last a LOT longer.. https://www.amazon.com/dp/B00HYYNW5K/ref=cm_sw_r_cp_apa_i_ElOEFbSW5GK1E
D**Y
Crumbles
Inferior product, cast aluminum crumbled first time I tried to air
N**N
Don't waste your money on these.
Absolute trash. Nut was tapped crooked and the valve cores were overtightened. Save your money. I wouldn't put these on a powerwheel, let alone a motorcycle wheel.
Trustpilot
2 months ago
5 days ago