RV Designer1-1/8 Inch Collection L448 Cam Lock Econo 1-1/8" Thumb

Replaced the locking latches on my Rpod because the only way to close them was with the key and that is a huge pain in the buttocks. Since only one of two latches on every compartment door could be actuated without a key, the doors were starting to warp because nobody wants to use a key every time you go in your pass through. These worked very well and were a good value. Good match too. Used my old lever bits soni didn’t have to bend the new ones to the proper angle, though it wouldn’t have been too difficult, I’m just lazy. These are great.

Easy in stall

I purchased these to replace some locks for fishing rod lockers on a boat and while they are a good value they do come with some caveats . The cam locks work as intended however the metal tang that does the latching are weak and half the thickness of the old locks. The do the job however any force on the door will certainly bend them and pop the door wide open. Unfortunately I could not use the old tangs as they were totally different. As the saying goes you get what you pay for. Overall I am satisfied with the purchase they are not meant to keep the thieves out.

Fit and works as expected and easy to install and a great value

It was sturdy and fit well on my side box door.

Exactly what I needed

I used this on the sewer valve door on my fifth wheel. I did have to cut some plastic to make it work but it's now much better than the original and now it stays closed!

I ordered two of these to replace the latches on my RV storage compartment. These cam locks have smooth action and an open and closed position. The old latches I replaced would just spin and spin. Tightening was a challenge, I had to go to the hardware store for 3/4” washers, and they were hard to find. Ended up putting a rubber gasket on the face side, and a fiber gasket on the latch side. It was a little tight. Next time I would order the 1-3/16” to have more space for washers, but these will work. Very happy with the latch mechanism. The hardest part of the install was removing the old latches, but otherwise it’s a fairly easy job. Oh, one more thing, you’ll need a 7/8” or 22m socket to remove or install the cam.

perfect fit and finish. All hardware supplied. Terrific purchase and price. Make sure you measure correctly for exact fit.

Fonctionne bien

Does what it is to do works ok minor adjustment needed to the tab

Rien a dire

good quality