URSEND for iPhone SE LCD Touch Screen Display Digitizer Screen Replacement Assembly White with Repair Tools

The screen replacement is good quality. However i encountered a small problem. At the top, the screen won’t clip all the way in as does the bottom portion of the screen. I’ve followed installation procedure as told and even disconnected the screen back out to see if there was anything in between the screen and there wasn’t anything that could limit the screen from not clipping in all the way.Needless to say though, the screen is good quality as mentioned in the beginning. Image does come up, and everything works great.

Good kit. I replaced screen in kid's iPhone SE using this kit. I used step-by-step guide from iFixIt. Everything worked out as expected. I didn't need any extra tools or parts other than what was in the kit. Complete replacement took 25 mins. All functions were tested ok after screen was replaced.NB: (1) be careful when removing home button connector retainer (small shiny spring-loaded bracket) - it will fly off.(2) make sure to unplug battery connector before working on other connectors(3) the upper right screw of the main board connector cover shield is non-magnetic. It will not hold to the screwdriver.

This is my fourth screen for my iPhone SE but I thought I would risk it this time to get the cheapest I could find and this one is not only the cheapest but the best quality I’ve seen! The other screens seem to have less pixels for some reason but this one is as sharp as the original. Will definitely buy again is I break this one again. Note that a screen protector will come in handy since this one doesn’t come with one.

Was a little difficult to change out but I was able to successfully swap the screen and have no issues. Next time I would rather buy one with a button as well.

The screen worked perfectly. The install did take some time. You need to transfer some stuff from the old screen to the new screen in order for everything to keep working. I actually wore nitrile gloves because I read oils in your hand could interfere with the cellular signal. You need to be very careful and make sure you don't break anything!

After finishing the installation, the touchscreen worked fine and display looked good, but the screen was quite dim! I would say the maximum brightness is about half of what it was on my old screen. So, if this is for a backup phone, you might be fine. However, I'll probably buy another replacement from somewhere else when it gets too annoying and do the repair again.Note: I followed the iFixit guide and had no problems. It took about an hour (or maybe a bit more). Word of warning: you'll have to follow the links to additional instructions for replacing the earpiece speaker, front camera etc. It adds about 30 minutes to the whole thing.

This is the third time I’ve replaced a screen for an iPhone SE, but the first time using this specific product.The product is installed amd works, but the replacement screen was missing instructions and a couple of thr tools to get the job done (was missing tweezers and a pry tool). The phillips screwdriver it came with also was an abnormally cheap POS and stripped after the third screw. Luckily I have a set of jewler screwdrivers for my glasses, and those are apparently quality enough for the job.I would reccomend another replacement screen.

Just good to replace a broken screen.Quality of color and touch is less than 50%.