Krylon Snap & Spray Reuseable Spray Paint Gun For Cans

I used this "gun" today to paint the door of my car. You have to slip it on to the paint can top at 90 degrees: the bottom of the gun clips onto the top of the can. It took me a couple tries and a serious shove but on it went. After that, the painting was a breeze. I did 3 coats over a couple of hours and the ease of using this handle instead of tapping the top of the can really protected my finger and felt a lot better. It popped off when done without difficulty and I can reuse it. Will buy again.

I’ve been spray painting for fifty years. Why I didn’t get one of these before I’ll never know. This makes painting with a spray can easy and enjoyable. Pressing the trigger on spray cans causes my hand to cramp and hurt, with this tool I could paint all day with no problem! And some have said they had difficulty putting it on the can. It went right on for me, snug enough to stay but easy to slide on. I use Krylon, I don’t know if other brand cans might be different or not.

Makes using a spray can almost like a spray gun. Worked really well, sprayed a whole roof top tent

Just like so many reviewers say, this is VERY difficult to put on and take off. The fit is FAR too snug. This will likely cause it to either prematurely break or damage the sprayer on the paint can. Make sure the sprayer on the can remains facing away from you while you struggle to put it on, because it could very likely slip from the force you have to apply to the trigger to get it to snap on.

.

I had a lot of patio steel fence to paint. This spray can holder will make painting really easy and will not give you a finger cramp. Allows spraying and any angle and makes the work much faster. Get one.

I am not a good spray painter but this was a GREAT TOOL I sanded and put a new coat of paint on my camper shell I recommend this product

So, at the risk of sounding like a fool, I would like to point out for anyone who is planning to buy this product because you have a bunch of cans of Krylon spray paint sitting around 3/4 full because the nozzle stops working, this product is absolutely useless to solve your problem. It’s just a trigger that pushes down the existing nozzle for you. I am so freaking frustrated with all of these cans of spray paint that I got 1/4 to 1/3 out of. I would stop buying their terrible product altogether if Krylon, super flat camouflage wasn’t the only thing that primes 3-D prints well. So, here I am, desperately trying to find a product to fix the problem with their product.