(2) Front Sway Bar Bushings FITS Camry Avalon Highlander Corolla Matrix Pontiac Vibe RX350 RX330 RX440H, Made In USA - 23.5 mm Diameter Bar

Used these on a 2010 Corolla S. These are good solid bushings. Takes a bit of effort to install especially on the Drivers Side. You'll need to use a basic 12mm Box Wrench to do that side because even the smallest sockets won't get past the Brake Lines easily...no problem on the passenger side though. These Bushings are very solid and quite durable. Recommend Silicone Lube on the Sway Bar where they mount and slide them inward from the outside of the sway bar. You may also need a large screwdriver to leverage the bar up a bit to slide them in further to their final position!

Received these and upon inspection and research found these fit Japan built not US built 2004 Camry. Look at your door jam info. Mine was built in Kentucky. Go to a Toyota dealer, and without the VIN, there are two possible PN.Suspension Dudes customer support is in contact. Will update after install.Installed. Worked great. Fit just fine. Tight bracket closed the bushing fully. Clunk going over uneven surfaces is gone. I was lucky working on a California based car, so no rust. Had to lower the subframe slightly to remove the rear bolts.

First - seems to perform fine but definitely not super close to OEM design - it is missing the low-profile "locator" button on the bottom that the OEM version uses to help ensure proper location in the mount.Tip for Install - I thought I was going to have a nightmare uninstalling and installing because it is super tight everywhere in that area and my big meat claws are too big for most voids. BUT I discovered by accident that you can't see from underneath the car - you can reach in from the side above the suspension A-arm on both sides to access the engine-side bolts with reasonable tools like a 1/4" or 3/8" socket wrench with extension and 12mm socket. It's even possible with a 1/4" and no extension but more difficult. Once that was figured out, it was pretty smooth sailing. Once the sway bar is released, it easily moves around mostly where you need it to stretch and snap on the new bushings. Probably the trickiest part after that is getting the assembly compressed enough to positively start the bolt threads by hand so you don't cross thread - take your time here and make sure you get it right. My conclusion after installing this is I probably need to replace the sway bar links again even though they only have 85K miles - much of the banging abated but front end still makes a bit of noise and those links don't look great.

Fit on my car perfectly. Works greats

My car was making noise over bumps and after I replaced this bushings the noise went away

Como lo esperaba me resolvio el problema 100%.se ven muy buenos .gracias.

Put these bushings along with sway bars (front & rear) from an 05 Corolla into my 05 Prius. The Prius handles so much better now. It's a fun car to drive now.

These bushing fit my 2011 Camry perfectly. I don’t recommend running just the front ones as you should get urethane bushings for the rear too. With both sets on the car, it will have a sharper feel towards it and will not sway back and forth when making turns.

Quitó el ruido que tenía la barra estabilizadora 🙏🏻 ahora la conducción es suave y sin ruidos molestos

Nice bushings however didn’t fit my application