Rostra Front-Mount Parking Assist System (250-1920-FZ)

This works very well. I even measured the distance readings with a tape measure and was a bit surprised that they were completely accurate to the inch. The kit itself is really well put together. I've installed lots of electronics in cars over the years and never had a kit come with everything you need all wrapped in wiring sleeves. Everything is also all very well marked and labeled for easy install.It is super easy to install but it is a minor vehicle modification, including drilling holes in your bumper and running wiring through the engine compartment and firewall, so if you're comfortable with doing stuff like that you'll find this an easy install.

Junk. Bought two of them. First didn't work, company was horrible to deal with outside of warranty. So tried one more, same problem. Bought a competitors system for $14, works perfectly using same holes in my Tundra bumper.Their help line person, a guy, was rude and unhelpful. Condescending.

Great kit with high quality cabling accessories (cable sheaths, connectors, labels), sufficient length of cables for any routing path.The distance measurements are exact.With the ODB2 connector, the driving speed activation/deactivitation does the job perfectly without connecting to the CAN bus wires separately. Mounting as per pics on my F-150 worked well with the supplied drilling tools.The only minus is that the installation manual has a few bugs and does not even show the wiring kit with the ODB2 connector

Just finished a successful installation on my 2015 Ford Edge. Everything works as described but the distance display LEDs are too dim to see in daylight without adding a shield of some sort. The supplied kit is complete and well-thought off.A few points that need improvement:1) The sensor wires are one long stretch. If, like me, you'd like to remove the plastic bumper from the vehicle for some reason in the future, you'll need to disconnect them from the sensors first -- impossible in my case because one can't stick their hand in there. I wound up tucking all the extra length under the bumper, to allow pulling it a few feet away without disconnecting anything. Would be nice if these wires were detachable at some point along their run, preferably near the edge of the bumper (and I would have been happy to spend the few extra $$$ for that).2) The power wire is of very thin gauge. Fishing it through the maze of obstacles under the dash felt scary. If that's your situation, I'd recommend splicing in a few feet of thicker gauge.3) There are two options to connect power (one with a switch, the other without) and two options for the CAN hookup (one of plugging into the OBDII port, the other hard-wired) but not a word about all that in the instruction booklet. My guess that I can use either of each was confirmed by a call to the support number (answered promptly by a human!)4) The volume control and orientation switches are on the bottom of the display unit. If, like me, you are going to install it on top of the provided double-sticky pad, make sure to set both correctly first, or you'll be tearing the pad off.5) The connectors on the back of the control box disengage very easily. Secure with tape or some such.Installation difficulty depends on the vehicle but will definitely need some patience and problem-solving. Mine was tough: the huge bumper cover had to come off (requiring removing both front wheels, taking off their splash shields and removing the engine bottom shield); fishing the four sensor wires through the firewall grommet was challenging, and even finding an ignition-switched circuit wasn't easy (ended up using a fuse tap). Finding a good spot for the display can be tricky.Overall a very useful, decently priced product. Hope it lasts.

This is great. It installed pretty easily. I put it on my F-350 so I can park easier since my front camera is obstructed my LED lights and a light bar. I easily installed the sensors in the air dam below the bumper. Matches the black very well. I set up garbage cans and tested the sensors and they are right on. The display shows the distance in inches and it is very accurate..I was very surprised at its accuracy. Great product.

I have installed a lot of electronic components on my vehicles through the years, including parking sensors and this was by far the worst experience ever. The instructions that come with the sensor kit are lacking some critical information. There are no youtube videos available to show the process, so you are forced to call customer service/tech support. I spoke with Brian and John on five separate occasions and they gave the impression each time that they were not happy being forced to answer questions, and that I " should just read the manual". On the first call I find out they included the wrong manual, and they emailed me the correct one. The "correct one" was just as incomplete as the one I initially received, but had different diagrams.After all the calls, and the condescending responses, I still couldn't get the product to work completely, butI wont call them back again, since I was hung up on the last call.Bottom line, unless you know someone who has successfully installed one of these and actually gotten it to work, don't buy one.

Great product, parking sensors and Excellent customer serviceI called with a question and John resolved right awaySend me replacement display and isdued was solvedGreat company and customer suportThanksV