Beduan 2 Way Normally Closed DC 24V Electric Solenoid Air Valve 1/8" NPT

The media could not be loaded.  Made a miniature flame effect with it and it worked great. It doesn't say it is made for LP fuel gas so when it started to leak I assumed it was because the butane ate up the o-ring and that it would be impossible to fix. It was actually very easy to take off the coil and check the seal, where I found some plastic in there (my fault, got blown in from the jenky valve connection below) and took it out. I'm impressed with the size, cost and how easy it is to repair.

Used it in an Arduino project. Controlled a PVC "air-tank" pumped to 70psi. No leaks. Low coil current of ~500mA so I was able to use small 12v/1A wall-wart to power the whole project. Says it's rated to 115psi but I didn't try it at anything over 75psi.Response time is fast. I was using to control 100ms blasts and it worked fine.I can't comment on its ability to sustain continuous-on use (I only used it for pulsing).

Ordered 2 valves. I was not happy because of reduced flow (approx 1/8" oriface), sticking plunger on one valve, leaky NPT fitting on the other. Seller reached out and offered a refund after my low review which I find very excellent so I am updating my review. I refused the refund and kept the valves, I was able to repair them.

The media could not be loaded.  These solenoids are perfect for what I needed them for. If you have quarter inch at least lines and fittings. These solenoids exhaust and deliver a very decent amount of air pretty dang fast. Lifts and lowers my golf cart no problem

Worked good

It worked okay for 30 days, now it drips about 50 to 60 drips per minute under VERY low pressure. I use it to water a plant. I have a 32 ounce bottle of water suspended over the valve and connected to 3/8 inch tubing via 3/8 inch hose barb to 1/4 inch NPT adapter and it leaks even when the water bottle is less than one quarter full. That is abysmal. Also, the flow rate is around twice as slow as a $70 Parker/Skinner valve with the same orifice size. I have had the Parker valve for at least 10 years now and it still works flawlessly and does not drip or leak. At $11, I was okay with the low flow rate, but the rapid drip is unacceptable.

Wired this into my new CO2 engraver as an add on air source switch. Some of the programmed runs have thousands of activactions of the solenoid in the few minutes they run, to where it sounds like a little machine gun going off. Never misses a beat though. None of the steps get missed, all of the required air is there when needed. Seriously impressed. Buying another one just in case, but I don't expect to ever need it.

Exactly what I was hoping for. Would order from them again.

Hooked this between my compressor and my laser engraver to control the air flow to the nozzle - worked first time and simple to intstall the wiring. Works like a charm.

Lo vuelvo a comprar

does the laser air supply great

Il as fonctionné 5 secondes