Stainless #10 x 3/4" Hex Washer Head Self Drilling Sheet Metal Tek Screws with Drill Point, (1/2" to 2" Lengths in Listing) 100 Pieces (#10 x 3/4 inch)

I bought these to try instead of the phillips head self tapping metal screws that I usually buy in bulk. Compared to the old ones, these ones go through the metal like butter. Even tougher metals, which the phillips ones would normally bog down and strip out in, give these no trouble.I will definitely be buying more of these.

Used these for tracts for wiggle wire on my greenhouse. Perfect. Very strong easily goes through the steel. The socket wrench needs to be heavy duty 5/16” but works like a charm. Great product!

These don't handle as much torque as I was hoping for. They snap beyond 40 ft/lbs. I was using these in a steel vehicle chassis. I pre-drilled the holes too because I wasn't expecting the self-drilling bit to get through the thick steel. Generally speaking, they work pretty good and are priced fairly. I would buy them again.

These are self drilling (tapping) screws. You screw them in. They are a good quality (seemingly, I am by no means an expert on screws). I like them, I use them and I bought them because they were the best price. In my opinion, go for it.

Nice screws with a non-shiney finish. I've purchased stainless pieces that have a similar finish and they were said to be harder than standard stainless; this product doesn't make that claim, but it looks like it of that family of higher quality stainless

Cutting into the frame of my fifth wheel trailer has been no problem. Broke 2 when my drill was a little too off-set but when you got a bag of one hundred, not a big deal. Have ordered more.

Great product and price. One year outside no rust yet!

24 hours outside and the threads are showing signs of rust. So keep that in mind. I saw "stainless" and didn't think twice about it. Probably fine for my vinyl fence, but would not use these near salt water. 410 stainless is not 304 or 316. It rusts a little. It is also magnetic.