Spec-D Tuning LHP-NEO03JM-TM Dodge Neon Srt4 Black Dual Halo Led Projector Headlights

Easy installation! Some wiring but if you have wired anything in the past shouldn't be a problem. The beams of light are intense! And they looking great!

Good looking product but one of the halos burned out after a year or so. I owned another one prior to this and had halos and the leds burn out. Fitment isn't great, as it leaves a gap between the light and the gender, but only noticeable if you're up close.

It looks good but need a little bit of a bigger seel

Not as bright as my stock ones. Huge inch gap from my passenger side bumper and the new headlight. They look nice but are not great with how bright they are. I have an 05 neon sxt and they hardly fit. The plug ins are not the best you need to cut and splice and reconnect wires.

Perfect product nice halos great look on the car more sporty looking

Do Not buy have had them on my srt-4 for 6 months the plastic is full of cracks and scratches bad material . Do Not buy

I do not like the big gap that I now have around the frame of my car. Also, one of my LED bulbs will not make a connection so I have had to order a new bulb. My stock headlights were lame, if it was raining and dark then I could not see the lines in the road. These are definitely brighter but they are not standard automotive headlights so I am curious how much of a pain it is going to be to replace a light when it does go out.

They look great!Install was a bit more intensive than I expected. Some wiring is required as the halos and LEDs are not wired in.Installation instructions:Dismantling:* Take out the three 8mm screws across the top of the grill(to loosen the bumper) or remove the bumper.* Disconnect headlight and turn signal.* Remove two 8mm screws holding headlight in place (they are both very long with appx 1" of threads near the head.* Remove headlight assembly.Installation:* Twist the wire pairs together [black=negative][white=positive] (Do not twist the white wires together if you want the LED's to blink with the turn signal)* Using the wire couplings provided(4), wire the black/negative pair to the solid black wire on the turn signal(amber) and the white/positive pair to the black/green stripe wire. (To wire the LED's to blink with the turn signal, wire the LED's white wire to the other wire on the turn signal.) ***Note: Your wiring may be different. You can find out which wire is which by wiring the negative and then use a jumper from the white pair to the other ports on the signal socket after removing the bulb and turning on your parking lights and hazards.* Install the old turn signal w/ bulb into the upper hole in the new assembly.* Attach the headlight sockets together, making sure the seat fully.* Install headlight assembly in reverse order of the dismantle steps above.Note: When I installed the headlights there were some gaps around the outside edge, the rubber seal around the outside is a bit flimsy and flat from packaging. To resolve this, I used the rubber seal from around the old headlights as they were already formed to the shape of my front end. This worked great and left very minimal spacing.Don't forget to get them aligned!