Car Interior Moulding Trim, 3D DIY 16.4FT/5M Insert Pinstriping Tape Cars Styling Decoration Moulding Trims Strip Garnish Accessory for Car Dashboard (Red)

I wanted to add some red accents to my interior to go along with the red accents I already have on my exterior.Depending on your trim, this an be an easy or somewhat tricky install. I had to shave a bit of the insert portion of this trim in a few spots to have it seat properly.There are a also a few spots where it's a bit loose and keeps popping out, but I'm going to try adding a little piece of red electrical tape to thicken the insert portion and hopefully that'll help.Regardless this is a cheap, easy mod. If you change your mind in a few months and decide you don't like it, spend 2 minutes and rip it out. You'll still get longer enjoyment out of it than that overpriced sandwich you decided to pick up for lunch.Note: It is a tad "orangish" as some others mentioned, but not too bad. I still definitely a red. I don't have anything else that's red in my interior to compare it to, so visually it looks red enough to me.

Spruced up all the doors on a 2020 Ford Explorer ST. Fairly easy to do.The little yellow tool that comes in the kit really helps a lot with install and it also does help to have some actual panel removal tools for the install and for certain areas of the door panel, panel removal tools are required.In some spots of the door panel, I did have to use very small dabs of super glue to hold it in place. Krazy glue is my go to, it works and dries quick. I had previously tried Gorilla glue liquid super glue and that stuff is garbage, it didn’t work well at all.I almost got all 4 doors done with 2 of these kits but I fell just short on the last door, that being the passenger rear, I ran out of material with only the bottom part of the door panel left which is just 2 short pieces so I ordered a 3rd kit and I’ll have definitely extra to maybe find some where else to use.Quite happy with the final results.

And it needs to be more red and a little thinner pipe.

It looks great and works excellent I purchased an accelerant to make it stick better not sure if it would work without it and it's been perfect. I highly recommend

It’s ok but would be better if it came with some kind of adhesive and a better tool to tuck it in with but after getting my own adhesive and trim tool the front don’t look bad but now I may have to get some more to do the back to.

The media could not be loaded. Apenas ajuste para dos puertas y el contorno del stereo....ahora tendré que comprar otra cinta para las otras dos puertas?? Seguro que sí, pero no comprare aquí....después de esta compra y esperar el pedido que venía en chino y no podia cancelar , vi otras cintas que traían 4 veces más longitud por el mismo precio... además la tira qué se mete entre las molduras es muy pequeña y se cae a cada rato. Es molesto.No lo recomiendo busca una mejor oferta y mejor material

Fits great between soft and plastic moldings. Difficult to install between plastic molding pieces. Installs in seconds and it's easy to trim to size. Looks great and is holding up perfect after a few weeks. I went with electroplate red because I saw reviews saying red was too orange. The electroplate is definitely a shiny dark red, but it looks good and is not orange at all.

wasn't too hard to install and I really like how it turned for about 45m of effort. I found it helpful to start from the bottom and work upward along with using the handle part of the tool to press it was easier for me.