Laser 3694 Drywall Bit Set 5pc

With 20 years Drylining experience i feel i am qualified to give my opinions on these excellent drywall Bits.If you are not experienced in this job you won't know hand fed electric drywall screwdrivers have a clutch. Basically, when you press the trigger nothing happens. It's only when you press the screw against the surface of the plasterboard that the cogs engage and drive in the screw.(like a clutch in a car) This action enables the depth gauge to work so NONE of the screws go in too deep breaking the paper making the fixing worthless.So, The vast majority of these Bits you see in cataloges and on the net are totally rubbish in my experience. The trouble is the cone on the end is fixed to the bit. So there is no give to allow for correct depth, they just shoot in the screws, the screws break the paper making the board incorrectly fixed thus waiting to pop and come loose. Ceiling board comes down and everyone is unhappy.Whereas the cone on these bits have a couple of millimeters give, allowing for correct depth, turning your drill that has a chuck, into and effiecient drywall screwdriver. Put on a low speed if new to this.Naturally i use a professional gun most of the time. But on occasion when there is no mains power i will use a cordless with one of these bits in and they are just as good as my £100 plus driver. Little slower yes, but if you are a joiner etc who does a bit of plasterboard work on occasion buy these to put in the end of you cordless drill. They are second to none. Or a diy person, these will be the best buy you'll get for under a £5. And one bit lasts ages, over 1000's of screws.Happy ScrewingFreddiebooks

They do the job they are meant to. not the best bits but adequate for a DIYer

Good value and work really well resulting in nice below flush finish and seem hard wearing.

Spot on

They’re ok but I didn’t think they were any better than an ordinary screw bit.Soon went back to ordinary drivers

Works great for drywall/plaster board installation with any regular driver. Value for money, seriously.

I've only used one of these on a small job so far. So it worked like it's supposed to but too early to give it 5 stars.

These work really well allowing you to go for it with your screwdriver without punching a bunch of big holes in your plasterboard. Really speeds up DIY work.