FXC Rocker Switch Aluminum Panel 3 Gang Toggle Switches Dash 5 Pin ON/Off 2 LED Backlit for Boat Car Marine Blue

Great product works great would recommend other people and if ever needed would buy again

Switches seem well made. Work as designed. It's China made, I'm not sure how it will hold up in a marine environment after some heavy use but so far so good. Be aware that it's pre-wired so all switches would run off of one breaker. As in 1 ground and one hot for all switches. This ofcourse will not do if you want your wiring done properly. When you try and remove the wiring that comes attached, it is very easy to break the switches. They are extremely tight and the retainers do not release them at all.. you must remove most of it to run them properly through a breaker or just on their own circuit etc. I have a total of about 25 of these switches on my boat, and out of 25 I broke 3 removing the series style wiring. I was extremely careful and have proper tools. I do 12 volt wiring daily as part of my job. So yes, they are pretty decent switches. Especially for the price. But beware you may break one or two to install them properly.

It's a great product and a great price.The stock harness is kinda laughable & they don't have a pin out - but a couple seconds of testing and you can easily wire them up however you want. Out of box, the harness caused the small slit lights to stay on at all times. Easily unhooked though and I'm gonna see if my dash light dimmer will drive those. The connectors are an odd locking type that I don't care for - so I simply used standard blade terminals and boom - not an issue.They are almost identical to stock 1989 jeep wrangler switch mounting. I just kissed the plastic with a dremel and the fit right in and locked and all. Creme de LA creme. It was a shame to discard the mounting plate. It was a pretty nice part. Well machined or however it was made.Cheap and seem good so far! When they get some weather exposure I may need to add a review suffix.

I purchased these switches to use for switching low voltage (12 VDC) outdoor patio and landscape lighting. While I'm still building the patio so I don't have them installed just yet, I have tested them, and the small blue constantly "on" light on each one provides an easy way to locate the switches in the dark. Of course the larger blue light provides a clear indication of a switch being in the "on" position.I'm going to position them on the corner of a masonry clad outdoor kitchen, just under the countertop level. I found a weatherproof plastic box here on Amazon with virtually the same length and width dimensions as the switch panel, and cut out an opening to fit and mount the switches. The box will mount to the concrete block structure of the kitchen, and the stone installed on the face of the block will butt into the box providing just a slight reveal so the switches are easy to get to.I obviously don't know yet how well the switches will hold up over time. The reason for 4 stars vs 5 is because the rubber gasket seal under the bezel of each switch probably won't adequately seal the switches from moisture without some help since the switches don't fit as tightly against their panel as they might. So I'll probably not use them and instead put a tiny bead of silicone around the back side of each switch. Other than for this, the switches look and operate nicely.

Todo muy bien, el producto Llegó en perfectas condiciones y antes de tiempo estipulado, precisamente lo que necesitaba, Muchas gracias

The 4 gang rocker switch panel is excellent! Instructions were great, the pre wired jumper cables are excellent, and they really add a nice ambiance to my car, I replaced one of the rockers with a horn rocker for my train horn! Definitely a good product!

The metal panel these are on is very nice, and nice clean wiring between the switches, as well as including a TON of stickers with various symbols or labels to label each switch with what it goes to. There's a small light on when the switch is off, and a bigger light on when it's on. Easy to see them in the dark whether on or off. However they do seem cheaply made and have 1-2 mm of play in them. I mounted them on my kayak to run my fish finder, cabin lights, and nav lights.

Happy with the quality of the switch. There seems to be some confusion about the indicator lights in some of the reviews. There is a thin light toward the bottom of each switch that stays on at all times when there is power to the switch. This makes it easy to locate the switch in the dark. There is also a larger square light toward the top of the switch that comes on when the switch is in the on position. I used a three gang switch for the exterior lights on our fifth wheel RV and it works perfectly