Pack of 5pcs 12 Inches Short Adhesive Table Sticky Measuring Tape Ruler Self-Adhesive Tape Measure (Inches)

It is easy to read both cm and inch. the tape has a good adhesive and sticks well. I love it.

These are a great addition to my paper cutter. You can always use another ruler on your paper cutter, or just use it to cover the "small" printed measurements so they are easier to read. I used on a couple on my cutter, and gave the others away to my crafting friends for their paper cutters.

This has is a decent zero center tape, the measurements are mostly accurate although there is about a 32nd of an inch disparity over 12 inches on either side when lined up against a known accurate measuring device (red expensive 🇺🇸 USA MADE rule that is named after a bird). The adhesive quality is questionable and time will tell. The tape isn't thick and shouldn't get caught on anything easily, though time will tell for that as well.

Used these on equipment at work and there still holding up. Would recommend.

This is great for placing on the edge of the sewing machine top. It sticks well to the surface of my cabinet.

I used this to put gradations on a jig I made to measure the inside diameter of whisky barrels at various points. I'm cutting circles with beveled edges to fit exactly in the barrel, so needed accurate readings. I cut the tape strip down the middle and stuck the Imperial scale on one side and metric scale on the other. They stuck well to the smooth maple sides of the device. I was disappointed that the Imperial side only measured to the closest 1/8", so I used the millimeter side for greater accuracy. I put another of the strips on my circle cutting jig so they were both using the same scale, and in the end it worked very well. Some of the other reviews showed much smaller gradations, though the actual ad truly shows them in 1/8" increments.

I have these stuck all over my woodworking tools. They stick; they stay. They are sturdy but thin enough to have tools slide over them.Examples:Mitre saw, router table, table saw.I've bought them twice, but I think these are slightly better than before. And you get more in the order.Highly recommend!

So I had to login and recheck to verify I didn't accidentally click the incorrect version for my project. A co-worker did point out not to click the CENTER-OUT version, which I am very thankful for that. However, when I opened the little plastic package, I noticed these were printed right-to-left instead of left-to-right like the photo shows. I figured that since there was 5 included, maybe I got a mix-and-match - which I did not. I can use these on the opposite side of the board I am making, but I need left-to-right for the other side. Once laid out off the backing paper, these were measured and showed very accurate to the 12 inch mark.