SEM39863 Plastic Adhesion Promoter Aerosol - 14.8 oz.

Great

I am putting my 2015 Tacoma back together following an unfortunate incident with a deer. I opted for unpainted versions of the bumper cover, bumper cover extensions and headlight filler panels because painted ones were either unavailable or substantially more expensive. I spent hours watching You Tube instructional videos and every one insisted that a plastic adhesion promoter was step one for finishing plastic body panels. This went on well. I have just finished applying this product followed by a primer-sealer, the color coats and finally the clear coat. At this point, I cannot comment on adhesion because it hasn't yet stood the test of time, but I am fingers-crossed.

You may be tempted to skip this stuff but don't. It really works and my panels came out great. Follow the directions.

It really helps bond the paint to a good prepared surface area. Will definitely get more for my truck project

Restoring my 06 Dodge Ram 2500 5.9 Cummins. The plastic door panels were severely faded and sun damaged. The only reason I purchased this item is because, it was recommended to do so. I'm a stickler when it comes to recommendations. And it makes sense to do. I have dyed or painted plastic auto interiors in the past without any prep adhesion, I can asurdly say, they did not hold up very well. Pricey is an understatement, but I would recommend doing this step, if only for peace of mind. + I plan on driving this truck for another 16 years.

We purchased all the spray products, from the adhesion promoter, primer, color coat, and clear coat satin finish. In addition to following the can direction, we also followed some very specific technique directions we found on the internet, about painting plastic dashboards (which was the project). Basically, follow all can directions, GENTLY and LIGHTLY WET sand the surfaces with 800 grit, dry, and clean well with alcohol before starting.Start with adhesion promoter, follow can instruction.Then spray primer, color, and clear coat in 2 - 3 very light coats, each, and when you finish all primer coats, wait 24 hours to start color coats, and do the same when color coats are done, and you are ready to clear coat the piece(s). We allowed all of that to dry for 48 hours, before reinstalling.It looks wonderful. Not like we just spray painted a dash. It's a hard finish, and no chips or scratches when it was re-installed in the vehicle.Compared to spray paint, it's a little pricey, but it was well worth every penny.

The media could not be loaded. Used it for the interior of my car. This adhesive spray worked great for the interior car paint.

Very good product I highly recommend it