LED Strip Solderless Connector Adaptor for 10mm Wide 5050 RGB Waterproof Led Strip Light (4 Pin RGB Strip Connector), Pack of 10

My cat scratched up a couple strips I had and instead of buying new ones I resourced to these and they certainly so the job. Super easy to use and work perfect fine, even overtime. The quantity is nice for the price. Overall great purchase!

I read reviews on how difficult these were to use, I found some ways to take some of the challenge out of these little clips.1.) Carefully peel back the thick clear rubber, take extra care not to tear the thin strip in any other areas.2.) When you cut the broken sections leave both sides of the copper contacts and fold along the line do not cut on the line.3.) Leave just enough of the thick rubber to cover the area you've just folded.4.) Using some sort of tool gently apply pressure to the pins to help pierce the thin portion of the strip. I folded the strip so there would be a definite contact on the pins. If I skipped this step it would sometimes flicker due to bad contact. After I folded it it was a solid connection.

This product did work but it is very finicky. I had to do like one reviewer did and trim of done of the silicon weatherproofing and fold the copper contacts. After doing that I got a great connection. When cutting the strip to size don't cut between the contacts, leave both sets on the part you are using. Strip the silicone off the copper connectors and fold them back. Should work after that.

You have to essentially break the product to open the clips. When you finally connect the strips, the connection between them is very poor, and the connecting LED strip doesn't get the correct amount of voltage to be the same color, or get any color at all. You have to use a vice grip on the clip to get the two strips the "same" color, and even then, it worsens the integrity of the first strip, so the two aren't actually the same color.

I was installing lights to my product table for events and I accidentally broke a strip. I used this product to splice a strip in to repair it. I am horrible at soldering and this saved my bacon. An extra set of hands might make it easier to use but I managed by myself.

They took a lot of manipulating to get them to work with my minger led strip lights. I'm going to use something else for my next room.

Literally took me 1 min to attached both ends . Make sure you have a small regular screw driver like the ones you use for glasses ans pop both leads at the bottom open. Connect both ends and close tightly. Worked first attempt.

So, after ordering these once and ending up having the package completely lost and untraceable, we got annoyed and ordered a second set after receiving a refund.While I can say we successfully set up the lights, I can also say it cost blood, sweat, and tears. And a roll of duct tape.These little mo*fo’s DO NOT let you know that you have to pierce your LED strip all the way through, nor do they tell you the copper side- if there is only one side with copper- needs to face against the prongs.We learned this the very long and hard way- that being repetitive trial, error, and screaming.Once we finally got the copper side down and clipped in the godawful things: that’s when we realised it needed to be pierced through. Piercing Daybetter lights does NOT happen with these! You have to shove your finger or any other small object down repetitively until it finally gives and makes a hole.All in all: it works. It’s just hell to get it there, and even once you arrive it’s noticeably imperfect (we had to use duct tape to provide pressure so it would keep the RGB+ connected properly to the prongs... for some reason??)Pros: tests if your marriage is meant to last. Eventually works.Cons: Even once you get it to work, the stress you’ve endured makes your victory bittersweet.