Skar AudioVX175-ST 1.75-Inch 400 Watt High Compression Aluminum Bullet Super Tweeters, Pair

If you don't have about 18 RMS minimum (not "peak" power) these aren't going to work well as a factory replacement. One look at the magnet on these things and you can see they're not meant for factory stereo duty. My head unit has 18 RMS and I went ahead and wired them in while I was working on the rest of the setup. I was able to dial them in by adjusting the individual speaker levels. If you have that option then you can make these work at a lower wattage.I eventually replaced the door speakers with these tweets and some mid range 5"x7"s that share a 100w rms high pass channel from my amplifier (50 watts RMS, .5-20KHz) and they sound amazing. They actually put out more DB compared to my mids than I would like but it's "good'nuf" for me. I just adjusted the fade more to the rear door speakers to quiet them down a little. Full tilt, I can hear my highs echoing off the nearby buildings, like an announcer on a PA at a baseball game. It's almost too much, so I didn't mind dialing them down a little.These have big magnets so they're heavy and the factory installed bass blocks have a single strand to connect to about the size of a paper clip. You will need to solder it to your positive wire or maybe use a crimp connector but you're not going to be able to do the old twist and tape install. If your system already has a crossover or capacitor inline to block highs then the pre-installed ones might be a problem.You'll need about 1.5 inches clearance from any metal due to the size of the magnets. I had to rethink my setup a few times because the original spot for my tweeters was in the a-pillar and didn't have hardly any clearance, and the 2nd spot I picked was too close to the door frame so the magnets were trying to attach themselves during install.I should note that no other tweeter I have installed handles the high frequencies like these do. I tried some DS18's and some Black Diamond tweeters. They weren't even close (and the DS18's both stopped working in less than 2 months). Granted, they ONLY put out the high end notes but they do it well enough that normal tweeters sound like mids. I'm going to order a second set for my other car. These are getting installed next to some Ford factory tweeters because they don't hit the highs well. Should be a perfect match. They will both share a 100w RMS channel with a 6" mid. I'm hoping 33w is the sweet spot for these since 50w was a bit too much.

Quality sounds in the vehicle

Love them. Do not dislike them at all. Amazing. Sound very loud. Very easy to install. The setup was easy. Great value for the money, the size and the look amazing. Thank you Tim from Michigan the clarity of it is amazing

These little guys can go get as loud as you want them to they will make your ear drum hurt lol. They are worth the money very happy with them. I dont have an amo for them the only power to them are from my pioneer radio.

These tweeters have an exceptionally crisp, clear sound. No distortion. The price? Can't understand how they are so affordable. The weight, alone, screams qreat quality. Well built. Highly impressed. I will definitley buy from Skar Audio again!

These are a huge improvement over my previous tweeters. They're loud and clear. I wasn't so sure of the fit I wish it had put the dimensions in the listing but I was able to make it work. I don't have any complaints honestly I will definitely buy this brand again

Great quality, performance is great and easy to install.

From Gerard Stroh****Very Awesome Horn Tweeters****