Trim Pot Adjustment Screwdriver (Trimmer Driver), 100mm. ENGINEER da-01

Purchased this for RF trimming and alignment , nice tool for the job - light and not long or bulky just right for the job.

Works fine. Used to fine tune the video output of one of my ZX Spectrums.

Interesting little tool. Used it a couple of times and no problems to adjust blow down timers.Lost a star as the tool is completely platic with a metal blade inserted in the tip, so I doubt it’s going to last long in my line of work. Quite a novelty to own and use.

Make setting up radios so much easier

Both arrived with the handles off. It looks like the plastic shaft is glued into the plastic handle - but the glue had failed.The shafts are not straight at all - and being not straight makes it difficult to turn trim pots in hard to reach places.I'll stick to buying the RadioSpares trim tools from now on. Even at twice the price than these, they are miles better than these cheap, Chinese bits of rubbish.If I could have given 0 stars I would have.I would avoid.

Does exactly what it says on the tin. No complaints, but it isn't a bargain.If you need a pot/cap/inductor trimmer with the minimum of metal in it - this is what you need.I can't say it is expensive compared to other trimmers, just it is a bit expensive compared to small screwdrivers....which isn't really a fair comparison, I admit.

I've used many potentiometer trimmer tools over the years but this is by far the bestRecommended

This does the job well enough. One size that does a lot of trimmers but not all. Be sure to check the size you need before buying.